Product Manual
Alarm.com Link
Product Manual
Caution
• Installation of the Link may involve high voltage components. Exercise extreme caution to avoid
electric shock. You must have appropriate licensing and adhere to all relevant codes for the
installation of this device.
• Before installing the Link, turn off all power to the HVAC system at the circuit breaker. Leave
power off until you have finished installing the device.
• The Link should only be used in conjunction with the included cable.
Box Contents
• 1x Link Control Unit
• 1x Cable
• 1x Port Splitter
• 1x Wall Bracket
• 2x Wall Anchors
• 2x Screws
Recommended Tools
• Drill
• 8mm drill bit
Compatibility
The Alarm.com Link is designed for use with Goodman Manufacturing ComfortBridge systems.
Link Overview
[Insert diagram of Link labeled w/ buttons & LEDs]
[CC1]
Buttons
• Network [insert radio icon]:
o Single Press: Places the device into add/remove mode
o Press for 10 seconds: Initiates a test for Network communication
• Test:
o Press: Calls for the fan to turn on for 1 minute, to verify system functionality and
communication
LEDs
• Power (Green)
o On – Powered
o Slow Blinking – Powering on
o Off – Not powered
• System (Green)
o Slow Blinking – ComfortBridge communication was not successful and reset in progress
o Fast Blinking – ComfortBridge initialization is in progress
o Variable Blinking – Indicates data traffic
o Off – No data traffic