POCKET DOOR INSTALLATION GUIDE
READ ALL INSTRUCTIONS AND REVIEW DIAGRAMS BEFORE BEGINNING THE INSTALLATION TO GET A THOROUGH UNDERSTANDING OF THE PROCESS. TOOLS NEEDED: • • • • Hammer Phillips Screwdriver Electric Drill Drill Bits STEP 1 Recommended : • • 2-1/2" Installation Screws 6d 2" Nails STEP 3 Arrange pocket door frame so that the header is resting inside the opening. If the pocket door frame is being installed in a rough opening, the header and end of frame should be flush.
STEP 6B STEP 5 Place pocket door frame into opening and shim until jambs are perfectly vertical and track is absolutely level (door will not stay in position if track is not level). After affixing header, ensure end-plate is fastened into wall stud using 2-1/2” installation screws. STEP 7 Make sure frame is plumb. Fasten floor mounting bracket with 2-1/2” screws into floor. STEP 6A Ensure header is level. Remove every-other screw from the header and replace with 2-1/2” installation screws.
STEP 9 STEP 11 Slide wheel-hangers onto track from either end. Mount door by inserting wheel-hanger into door plates. Ensure door closes evenly on jamb and that there is adequate clearance at floor. If adjustments are needed, raise/lower the wheel-hanger bolt, using the included wrench. STEP 10 STEP 12 After ensuring door is plumb and closes properly, you may now hang your drywall or wall boards and trim out your opening. 4 © 2016 OrePac Building Products. All rights reserved.