Quick Start Guide

48 Quick Start Guide 496262 INFINIUM/6262-212 INFINIUM/6260 INFINIUM/6260-212 INFINIUM
(EN)
Step 4: Wiring the
Bugera
(ES)
Paso 4: Conexion
del Bugera
6262 INFINIUM/6262-212 INFINIUM/6260 INFINIUM/6260-212 INFINIUM Wiring the Bugera
! Caution!
Hot! Risk of injury! During use, the valves will get
very hot and high surface temperatures may be
reached at the rear of this unit. To avoid burning
yourself, make all connections while the unit is
still cold.
! Attention!
To avoid damage to your amp, never use the
Bugera valve amplifier without a loudspeaker
connected!
If you only connect one speaker cabinet, be sure that
the IMPEDANCE switch is set to match the impedance
of the connected cabinet. If you want to connect two
speaker cabinets, both cabinets should have to the
same impedance.
CAUTION: The loudspeakers in the combos are
connected in series. This results in an impedance of
16 Ohms. Please ensure that the IMPEDANCE switch
is set to this value (16 Ohm when using combo-
version with internal speakers).
! !Precaución!
Peligro de quemaduras! Durante la operación del
amplificador, las válvulas se calientan mucho y,
por lo mismo, algunas partes en la parte trasera
también alcanzan temperaturas muy elevadas.
Para evitar quemaduras, realice todo el cableado
mientras el amplificador esta frio.
! Atención!
Para evitar danos al aparato, .no utilices nunca
el amplificador a válvulas Bugera sin tener
conectada una caja acústica!
Si utiliza solamente un altavoz, el ajuste del
conmutador IMPEDANCE debe corresponderse con el
valor de impedancia del altavoz conectado. Si desea
utilizar dos altavoces, ambos deben tener el mismo
valor de impedancia.
PRECAUCION: los altavoces incluidos en los combos
están conectados en serie, lo que resulta en una
impedancia de 16 ohmios. Por favor asegúrese de
que el conmutador de impedancia esté ajustado a
16 ohmios.