User's Manual

ManualsBrandsBudderfly ManualsElectronicsRF Outlet

Part No R0510021

Description:

Installing a Budderfly RF adapter transforms your building’s existing wiring into the “Budderfly Open Network” and allows the

adapter to monitor energy consumption and communicate the data to a facility controller.

Budderfly RF adaptors use the existing power line for communication and thus require no re-wiring; also it acts as an RF access point

connecting nearby Budderfly RF switches to the Budderfly network.

Using our Budderfly software, you can visualize consumption data and manage each individual adapter.

The Budderfly RF Outlet is a component of Budderfly system and designed to work with all other Budderfly devices. It is a plug-and-

play replacement for your existing Outlet. Once installed, The Budderfly outlets also act as repeater to extend the range of the

network and increase efficiency.

The equipment plugged into this Budderfly Outlet must not exceed 2400W at 120VAC.

WARNING –ELECTRICAL SHOCK HAZARD

 The Budderfly Outlet is intended for installation in accordance with the

National Electric Code and local regulations in the United States.

 If you are not knowledgeable or comfortable with electrical circuitry, you

should have a qualified electrician install the Budderfly Outlet for you.

Warning

 Install the Budderfly Outlets indoor only.

 Never use the Budderly Outlets to power medical and/or life support

equipment.

Summary of content (5 pages)

PAGE 1
Part No R0510021 Description: Installing a Budderfly RF adapter transforms your building’s existing wiring into the “Budderfly Open Network” and allows the adapter to monitor energy consumption and communicate the data to a facility controller. Budderfly RF adaptors use the existing power line for communication and thus require no re-wiring; also it acts as an RF access point connecting nearby Budderfly RF switches to the Budderfly network.
PAGE 2
Installation: The Budderfly Outlet may be used in new installations or to replace an existing Outlet. The wiring schematic will be as per below: WARNING –ELECTRICAL SHOCK HAZARD   Turn OFF the power to the branch circuit for the Outlet at the service panel. All wiring connections must be made with the POWER OFF to avoid personal injury and/or damage to the Outlet. 1. 2. 3. 4. 5. At the circuit breaker or fuse panel, disconnect the power for all of the circuits in the switch junction box.
PAGE 3
WARNING: If you are not sure about any part of the above instructions, consult a qualified electrician. Features: - Ability to create a group of devices Ability to monitor power consumption LED indicator to show the state of the Outlet Dual-band communication over both radio frequency (RF) and the power line. Device Grouping: Using the Budderfly software, it is possible to create a Group of Outlets.
PAGE 4
Communication: The Budderfly Outlets use the power line to communicate with the “Facility Controller”. The outlets can reply to the following commands:  Join/Disjoin group “X”: The outlet will Join/Disjoin the group ”X”. Each outlet can be a member of several groups at the same time.
PAGE 5
WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference received, including interference that may cause undesired operation.