MMC Control Operation Instructions for MMC Control System
Instructions to the User for FCC This equipment has been tested and found to comply with the limits for a class B digital device pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Dip Switch Table for MMC RF Board on 1 1 1 Maintained 1 2 3 Open is Open and Close is Close 1 1 Momentary to 1 on 1 Maintained 2 1 3 Open is Open and Close is Close 1 Momentary 3 Open is Open and Close is Close 1 on 1 2 1 1 Maintained 1 on 1 2 3 1 1 on 1 2 Momentary to 1 Maintained 3 Open is Close and Close is Open 1 on 1 Open is Close and Close is Open Momentary 1 1 2 3 Open is Close and Close is Open If switch 3 is off, the action is ‘open is open and close
Basic Wiring of MMC-RF Board Switch Pin Out for MMC Functional Explanation for Dip Switch
MMC Programming Up Channel Indicator Right Stop Channel Selection Button Left Down 1) Programming the Handsender for One Motor Note: To put MMC into program mode, unplug the MMC for 30 seconds and then reconnect. The program mode is now engaged for the first three minutes the MMC has been plugged in. When programming a new system, any Tumo systems within range that have been programmed within the last three minutes must be unplugged to prevent them from becoming reconfigured to match the new system.
MMC Programming 3) Delete Channel Settings at the MMC Using the CHANNEL SELECTION button, select the channel programmed to the MMC for which you wish to cancel the channel setting. Press and hold the UP and STOP buttons until the receiver reacts with 4 clicks. This channel setting has now been deleted from the MMC. If you now press or hold any of the directional buttons for that channel, the MMC should not click.
Connecting Tumo Xcel Drapery Systems to other controls The Tumo Xcel Drapery System can be easily linked with most third-party control devices through the low-voltage connecting port at the bottom of the motor. This port can be used to connect to both local and network controls. BTX Supply can provide technical assistance upon request to meet your project needs. With the Tumo Xcel Drapery System, only a BTX low-voltage wall switch is needed to perform control operations.
Warranty & Return Policy 1. Contract All offers, quotes and sales by BTX Window Automation, Inc. (BTX) are subject to these Terms and Conditions of Sale. No other agreements have been made or will be valid unless expressly confirmed in writing by BTX. 2. ACCEPTANCE BY TAKING DELIVERY OF BTX PRODUCTS, PURCHASER ASSENTS TO THE TERMS AND CONDITIONS STATED HEREIN, UNLESS OTHERWISE EXPRESSLY AGREED IN WRITING BY BTX.
