User's Manual

ManualsBrandsBTX Holdings ManualsElectronicsRF Wireless Wall Switch

Programming Wireless Wall Switch

Programming - 490.2076 - 040714

www.btxinc.com | 800-422-8839

CHANNEL 1

CHANNEL 2

CHANNEL 3

CHANNEL 4

CHANNEL 5

STOP

OPEN CLOSE

Wall Switch Layout

For all following programming commands, the motor must be placed into “Pairing

Mode”

Pair Handsender to Motor / Learn Channel

CHANNEL BUTTON &

INDICATOR (LED)

Instructions

Select desired channel, then hold Open and Close.

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Motor will no longer respond to this channel

Delete Channel from Motor

Select desired channel, then hold Stop and Open.

Select desired channel, then hold Stop and Close to

enter Programming Mode, then

Hold Open and Close to Reverse Direction, then

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Motor is in Programming Mode

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Motor will now work on this channel

Note: Each motor can learn up to 4 channels

Reverse Motor Direction (Electronic Limit Motors)

Expected Response:

CHANNEL

OPEN

CHANNEL

STOP

CHANNEL

STOP

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Travel direction is now reversed

OPEN CLOSE

Hold Stop to save settings and exit Programming Mode

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Settings are now saved

Select desired channel, then hold Stop and Close.

- The wallswitch will give a slow blink

- After 3-5 seconds, the motor will jog

- Travel direction is now reversed

Reverse Motor Direction (Mechanical Limit Motors)

CHANNEL

STOP

To Enter Pairing Mode Press and hold button on motor head for 2-3 seconds (until motor jogs). If

your motor doesn’t have a button on the motor head, you must disconnect power for 3-5 seconds,

then reconnect power. Alternate method: If the wireless wall switch is already Paired, then hold

STOP for approximately 5 seconds. Note that the motor will stay in Pairing Mode for 2 minutes. The

motor will time out on it’s own, and you do not need to save and exit from Pairing Mode.

Summary of content (2 pages)

PAGE 1
Programming Wireless Wall Switch Instructions Wall Switch Layout For all following programming commands, the motor must be placed into “Pairing Mode” To Enter Pairing Mode Press and hold button on motor head for 2-3 seconds (until motor jogs). If your motor doesn’t have a button on the motor head, you must disconnect power for 3-5 seconds, then reconnect power. Alternate method: If the wireless wall switch is already Paired, then hold STOP for approximately 5 seconds.
PAGE 2
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.