Quick Start Guide

CPX60P
Introduction Panel of device
· I/O Panel of CPE
1
· LED Panel of CPE
Packing list
Make sure you have everything you need to properly configure
the device.
If you want to remove the SIM card, please lightly press the
SIM card, the SIM card will pop out.Make sure the CPE is
turned off before you insert or remove your SIM card.
Otherwise, the CPE and SIM card may be damaged.
CPE Ethernet cable
2
How does it work
Configure hardware
Insert SIM card
3
4
LED behavior
When set up the CPE, the LED will have the following behavior.
Power supply
Please insert your SIM card as following:
The figure is just for reference only,
please connect the
hardware according to your requirements.
You may adjust the CPE's current position and direction to
obtain a better radio signal. To determine whether the CPE
is receiving a strong signal, please refer to the SIG LED
indicator.
Connect the supplied power adapter to the CPE.
·You can connect your computer or classic Switch via
Ethernet cable to LAN port.
Connect the other devices.
POWER
SIG
Indicator Status Description
Steady on
Off
Green
Power On
No Power Supply
5G
Blue CPE connect to 5G network
CPE connect to 5G SA network
Red Signal weak
Blue
Green
Signal good
Signal stronge
Blinking every 0.25s Searching network
Off No signal
Red/Green/Blue blinking
one by one every 0.25s
FW upgrade
Red/Green/Blue blinking
one by one every 1s
Off No network connection
No SIM/PIN lock/PUK lock/SIM lock
Indicator Status
--- WPS function.
--- Switch off/on
.
--- Turn off 5G function,
only connect to 4G, press again for 10s to
restore 5G function.
CPX60P aims to enable global carriers and partners to
experience the most advanced 5G experience.
With the CPX60P, users can enjoy wireless broadband without
limitation by cable or fiber, and an ultrafast internet service at
optical fiber rates in different senarios such as home, office,
SOHO environments.
5G CPE
Quick Start Guide
5
Login to the website
You should use a web browser to access to the web management
page to configure the CPE. The following procedures describe
how to use a PC operates with Windows 7 or above OS and web
browser to connect to the CPE web management page.
Launch the web browser, enter http://192.168.1.1 in the
address bar, and press Enter.
Enter the username and password, and click .
After the password is verified, you can login to the web
management page.
The default username and password are both admin. Please be
aware: When you login to Web management page, you will see an
un-safe notice beside to the URL bar and this is due to no built-in
SSL Certificate in CPE. However, there's no problem about security
so you may just ignore it.
Configure the CPE