TO TURN ON: Press the power key for one second until the LED flashes green, TC TURN OFF: Press and hold the power key for three seconds until the LED flashes red. NOTE: The Bridge 1 MAX+ includes Instant-Cn™, which means that reconnecting no longer takes seconds. Once paired, your keyboard will instantly connect to your Pad for up to 4 hours before entering sleep mode without impacting power consumption. TO PAIR: Press and hold the Bluetooth™ key for three seconds until the LED flashes blue.
Las TO INSERT. Place your Bridge on a flat surface and ~~ TO REMOVE: Place your Bridge on a flat surface. open the case. Place your iPad in the bottom of the Use the tabs on either side of the case to release case and lean it towards the back The magnets will the iPad. snap it into place. = TO CHECK BATTERY LIFE: In Today View, go to the BATTERIES section to check battery life. If not available, swipe left on your Home Screen to show Today View, scroll to the bottom and click edit.
MISE EN MARCHE ACTIVATION : Appuyez sur le bouton d'alimentation pendant une seconde jusant ce que le voyant clignote de couleur carte. DÉSACTIVATION : Appuyez sur le bouton d’alimentation et maintenez-le enfoncé pendant trois secondes jusqu'a ce que la voyant clignote de couleur rouge. REMARQUE : Le Bridge 11 MAX+ inclut Instant-On™, ce qui signifie que le fait de se reconnecter ne prend plus plusieurs seconde.
EEE FRED POUR INSÉRER : Déposer votre Bridge sur une POUR RETIRER : Déposer votre Bridge sur une surface plane et ouvrez Placez votre paddy sural surface plane. Libérez votre paddy de 'étui au mayen partie inférieure de 'étui et penchez-le vers garrigue, des anglets situés des deux cités. Les aimants s’enclenchent en place. = POUR VÉRIFIER LA CHARGE DE LA BATTERIE : Depuis la rubrique Toda Vies, accédez 4 la section BATTERIES pour vérifier la charge de la batterie.
This device contains license-exempt that comply with Innovation, Science and Economic Development Canada's license-exempt RSS(s). Operation is subject to the following two conditions: (1) This device ray not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with IC RS-102 radiation exposure limits set forth for an uncontrolled environment.
Cet appareil contient un émetteur-récepteur exempté de la licence CNR en conformité avec Innovation, Sciences et Développement économique Canada. Le fonctionnement de cet appareil est soumis aux conditions suivantes : (1) cet appareil ne doit causer aucune interférence nuisible. (2) cet appareil adit accepter toute interférence ressue, y compris celles risquant d’entraîner un fonctionnement préjudiciable.