High Line Track adaptor installation Sheet

BRUCK LIGHTING SYSTEMS
15774 Gateway Circle Tustin, CA. 92780
www.brucklighting.com
For more assistance with technical questions please call our
technical support staff at [phone]. You can also
contact us by email at [e-mail].
INSTALLATION AND WIRING DIAGRAM
IMPORTANT SAFETY INSTRUCTIONS
READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE FIXTURE
3 9/10"
1 3/8"
3 9/10"
1 3/8"
1.
2.
3.
4.
5.
6.
7.
8.
Read all instructions!
Turn off power prior to any work on the systems.
Only a qualied electrician should install this system power feed.
For all the wire connections, use UL listed Wire Nuts.
Only BRUCK xtures and components may be used with the system.
Total wattage of the system must never exceed the wattage supplied by the low voltage transformer. Please check that the total lamp wattage does not exceed
300W per circuit.
Secondary connections must be clean and tight to avoid arcing and overheating!
Warranty is void in case of unauthorized modications and/ or improper use.
Step 1.
HIGH-LINE
ADAPTOR I HORIZONTAL / VERTICAL, FOR 4” CABLE WIDTHS
- To change High-Line Adapter from vertical to
horizontal direction, remove cap (A).
- Remove screws (B) with allen wrench provided.
- Pull arms (C) from adapter, rotate arm and align
screw holes. Screw (B) arms back onto adapter, place
plastic lid (A) back on.
- To connect High-Line Adapter to cable, screw the
two allen screws (D) at the ends of the adapter to the
cable. Make sure screws have a clean connection to
the cable.
Contents of Delivery:
HIGH-LINE ADAPTOR I - qty. (1)
ART. NO. 150 360ch
150 360mc
chrome
matte chrome
A
B
C
D
3 9/10"
1 3/8"