SPECIFICATIONS Wireless Output: 5W / 7.5W / 10W Input: DC 5V / 9V Ports: 1 x Type-C USB Size: 127mm x 88mm x 50mm Qi WIRELESS CHARGING HOLDER Model: Qi-15-2.
Warning:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. PRODUCT LAYOUT NOTE:This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CONNECT YOUR HOLDER CHARGE YOUR DEVICE 1. Connect the Type-C USB cable to the holder and either the cigarette charger or install kit included. 1. Carefully slide your phone down the holder groves until it naturally rests at the bottom. 2. The LED indicator will flash red once then remain off while in standby mode. 2. The wireless charger will automatically connect to your phone and start charging. 3. The holder is now ready to start charging your phone. 3.
REMOVE YOUR DEVICE LED STATUS Standby mode = LED off Charging mode = Blue LED on 1. Your phone can be removed anytime while charging. Carefully slide your phone up the holder groves until fully removed. Fault / Not charging = Red LED on 2. The holder stops charging automatically when your phone is removed. 3. The holder LED indicator will turn off when in standby mode.