Installation Guide

ManualsBrandsBroan ManualsAccessoriesRange Hood Power Pack Ductless Exhaust Ventilation Kit for PM250SSP

1. Install PM250SSP per installation instructions shipped with power module.

2. Remove aluminum filter and attach the CHARCOAL FILTER (included) to the backside of the

aluminum filter with the 4 supplied metal clips.

3. Cut hole in bottom of SOFFIT to allow clearance for the 90° ANGLE BOOT.

4. Locate top of 4¼” X 10¼” OPENING on soffit - centered on POWER MODULE CENTERLINE and

26.125” above bottom of POWER MODULE.

5. Layout 4¼” x 10¼” pattern and cut opening in soffit.

6. Connect 90° ANGLE BOOT to 7” ROUND DUCT.

7. Insert boot end into soffit and connect 7” round duct end to the exhaust of the unit.

8. Install GRILLE (included - not shown) into soffit opening.

9. Use metal foil tape to make all connections secure and air tight.

INSTALLATION INSTRUCTIONS

358NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING

FOR USE WITH PM250SSP POWER MODULE

SOFFIT

CABINET

90°

ANGLE BOOT

(included)

7-IN. ROUND DUCT

(included)

PM250SSP

POWER MODULE

OPTIONAL METAL LINER

(LB30SS or LB36SS)

(purchase separately)

4¼” x 10¼”

SOFFIT OPENING

POWER MODULE

CENTER LINE

26.125”

CHARCOAL FILTER

(included) (99010464)

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS 358NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING FOR USE WITH PM250SSP POWER MODULE 1. Install PM250SSP per installation instructions shipped with power module. 2. Remove aluminum filter and attach the CHARCOAL FILTER (included) to the backside of the aluminum filter with the 4 supplied metal clips. 3. Cut hole in bottom of SOFFIT to allow clearance for the 90° ANGLE BOOT. 4. Locate top of 4¼” X 10¼” OPENING on soffit - centered on POWER MODULE CENTERLINE and 26.
PAGE 2
DIRECTIVES D’INSTALLATION ENSEMBLE DE CONVERSION SANS CONDUIT 358NDK POUR VENTILATION PAR LA SOFFITE À UTILISER AVEC LE MODULE MOTORISÉ PM250SSP 1. Installer le module motorisé PM250SSP conformément aux directives d’installation qui l’accompagnent. 2. Retirer le filtre en aluminium et fixer le FILTRE AU CHARBON (fourni) à l’arrière du filtre en aluminium à l’aide des 4 attaches métalliques fournies. 3.
PAGE 3
INSTRUCCIONES DE INSTALACIÓN JUEGO DE CONVERSIÓN SIN CONDUCTOS 358NDK PARA VENTILACIÓN EN PLAFÓN PASANTE, PARA USARSE CON EL MÓDULO ELÉCTRICO PM250SSP 1. Instale el PM250SSP según las instrucciones enviadas con el módulo eléctrico. 2. Retire el filtro de aluminio y fije el FILTRO DE CARBÓN (incluido) en la parte posterior del filtro de aluminio con los 4 sujetadores metálicos suministrados. 3. Corte un orificio en la parte inferior del PLAFÓN para dejar espacio para la TRANSICIÓN EN ÁNGULO DE 90°. 4.
PAGE 4
Broan Hartford, Wisconsin www.broan.com 800-558-1711 Venmar Ventilation ULC Drummondville, Québec www.broan.