CB2470 Bluetooth Wireless Audio Adapter User’s Guide i
FCC Caution 1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. FCC RF Radiation Exposure Statement: The equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
End Product Labeling This transmitter module is authorized only for use in device where antenna may be installed such that 20 cm may be maintained between antenna and users (for example access points, routers, wireless ADSL and similar equipment). The final end product must be labeled in a area with the following: “ Contains TX FCC ID: I4L-MS6855”. Manual Information for End Users The end user must not have manual instructions to remove or install device.
Introduction >>> 1.1 Bluetooth Wireless Audio Adapter The Bluetooth Wireless Audio Adapter - CB2470 (hereafter called CB2470), compliant with Bluetooth Specification v1.2, is a high-efficiency wireless audio adapter for MP3 players, mobile phones and PCs. The transmittion distance can be up to 30 meters. With CB2470, you can use MP3 players, mobile phones and PCs wirelessly through Bluetooth connection. The CB2470 is compatible with above devices wihout drivers needed.
>>> 1.2 How CB2470 Works Step 1: Press and hold the Power/Pair button for 3-secs irregardless of whether unit is in Stand-By mode or Pair and Connect mode. The Bicolor LED will then alternate between blue and green. Step 2: When paired successfully, the LED will convert to blue colour and will start to blink once every 5-sec. Blue LED will blink once every 10-sec when audio streaming and once every 5-sec when not.
>>> 1.3 Product View LED Indicator Power/Pair Button Turning on the audio adapter Press and hold the Power/Pair button for five seconds. LED will light up for 0.3 sec. Thereafter the audio adapter will autodetect and connect to the paired devices. Turning off the audio adapter Press and hold the Power/Pair button for five seconds. Thereafter, all LEDs will then turn off after lighting up for 0.3 sec.
>>> 1.4 Specifications 1.4.1 General Power Source Storage Temperature Operating Temperature Firmware Upgrade Low Battery Indicator LED Buttons Auto-Power Off 1.4.2 Audio Features Audio Sampling Line input gain control Impedance Stereo Line 1 x AAA Battery 0°C - 70°C 5°C - 55°C To be upgraded at Factory Level via contact points located at Batter Chamber. Green LED will blink twice rapidly in succession for every 5 sec interval.