User's Manual
OEM Installation Guidance Document
For Broadcom 802.11ax WLAN PCI-E Custom Combination Card
BCM94389FCPAGBE
FCC ID: QDS-BRCM1095
Page 1 of 3
The Broadcom module is only offered for sale to a specific OEM manufacturer that
incorporates this module design into a host system. The radio module is not for sale
to end users and consumers.
Conditions on using BRCM regulatory approvals:
A. OEM manufacturer must ensure that no changes are made to the Broadcom
module and acknowledges that any modifications may invalidate regulatory approvals, or
may necessitate notifications to the relevant regulatory authorities.
B. OEM manufacturer is responsible for ensuring that antennas used with the
product are of the same type, with same or lower gains as approved and providing
antenna reports to Broadcom.
C. OEM manufacturer is responsible for regression testing to accommodate changes
to Broadcom’s designs, new antennas, and portable RF exposure safety testing/approvals.
D. The Broadcom module is only FCC authorized (certified) for the transmitter-
specific rule parts, FCC 15.407. OEM manufacturer is responsible for compliance to all
other FCC rules that apply to the host.
E. Host devices sold in the US and its territories must not be labeled with “Contains
FCC ID: QDS-BRCM1095”, unless the US country code has been programmed in the
module.
F. OEM manufacturer should perform additional verification/validation on
supported modes and is responsible for validation testing of module + host.
G. Appropriate labels must be affixed to the OEM Product that comply with
applicable regulations in all respects.
H. A user’s manual or instruction manual must be included with the OEM product
that contains the text as required by applicable law. Without limitation of the foregoing,
an example (for illustration purposes only) of possible text to include is set forth below:
1. USA—Federal Communications Commission (FCC)
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.