Assembly Instructions Caution: You must read this before you proceed. Armless Chair Caution: This Chair is NOT a TOY. Keep your child/children at bay during the assembly process. Whenever moving/lifting the Chair and to prevent damage to the Chair, two adults are needed to execute these actions.
Part List Description Qty A1 Backrest Panel 1 B Left Panel (with Pre-installed Levellers) 1 B1 Right Panel (with Pre-installed Levellers) 1 D1 Seat Panel 1 E1 Back Support Bar 1 F1 Front Support Bar 1 G Seat Cushion 1 H Back Cushion 1 Description Qty ① Bolt (M6x35mm) 9 ② Screw (M6x55mm) 5 ③ Allen Key 1 Label Picture Hardware No.
Assembly Preparation Before Beginning Assembly: Assembly Steps Overview Backrest Panel (A1) Back Cushion (H) Right Panel (B1) Left Panel (B) Back Support Bar (F1) Seat Cushion (G) Seat Panel (D) Front Support Bar (E1) FRONT FACING This Armless Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Armless Chair parts, the above picture is to help you put the various parts into perspective.
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Place Left Panel(X) facedown as pictured. Insert dowels on Back Support Bar(E1) and Front Support Bar(F1) into mountings on Left Panel(B). Attach Back Support Bar(E1) and Front Support Bar(F1) to Left Panel(B) using Bolts(①) with Allen Key(③). Do not fully tighten the Bolts.
Step 3 Insert dowels on Backrest Panel(A1) into mountings on Left Panel(B). Attach Left Panel(B) to Backrest Panel(A1) using Bolts(①) with Allen Key(③). Do not fully tighten the Bolts. Step 4 Place the Right Panel(B1) facedown as pictured. Insert dowels on Backrest Panel(A1), Back Support Bar(E1) and Front Support Bar(F1) into mountings on Right Panel(B1) as pictured above Attach Right Panel(B1) to Backrest Panel(A1), Back Support Bar(E1) and Front Support Bar(F1) using Bolts(①) with Allen Key(③).
Step 5 Stand the Chair frame up. Insert Seat Panel(D1) onto Chair frame as shown above. Attach Seat Panel(D1) to Right Panel(B1) and Left Panel(B) using Screws(②) with Allen Key(③). Note: Insert Screws(②) from inside to outside of Seat Panel(D1). Do not fully tighten the Screws. Step 6 Adjust Pre-installed Levellers height for balance Inspect the Chair and make sure all parts are adequately connected. Carefully sit onto the Chair. This pressure will help align all parts at all joints.
Step 7 Place Seat Cushion(G), and Back Cushion(H) onto the Chair, and affix the velcro straps around the Chair as shown above. Your Armless Chair is ready to be used. This Armless Chair can only be used on a flat, level surface. Step 8 With assistance from your adult partners, place the Chairs facedown and connect the pre-attached clips to connect the Chairs together.
of 8