FCC ID: QVL-MIP5 Page 1 of 7 APPENDIX J INSTALLATION MANUAL EMC Technologies Pty Ltd 3/87 Station Rd Seven Hills NSW 2147 Australia Tel: +61 2 9624 2777 Fax: +61 2 9838 4050
For further information or to find out more about our range of smart card and biometric solutions, visit BQT Solutions on the web at: www.bqtsolutions.com Alternatively you can contact us at one of our global locations. AUSTRALIA & ASIA PACIFIC Level 4, 65 Epping Road North Ryde NSW 2113 Australia phone: +61 (0)2 8817 2800 fax: +61 (0)2 8817 2811 email: info@bqtsolutions.
INTRODUCTION Thank you for purchasing the miP5 Mifare Contactless Smart Card Proximity Reader. ® WIRING SCHEMATIC Reader Connection The miP5 is used in security applications and interfaces into Wiegand applications. The miP5 is preset with BQT’s proximity 'Keys' and valid smart cards are issued with corresponding 'Keys' thus ensuring that the system cannot be compromised. The reader incorporates a LED to provide feedback to a person wishing to enter. The LED is controlled by the security system.
WARRANTY The miP5 comes with a 5 year warranty from the date of dispatch from BQT Solutions. The warranty is void if the instructions contained within this manual have not been adhered to. See the BQT Solutions website for further terms and conditions. 30 30 Wall View SPECIFICATIONS Reader Output Wiegand Power requirements 12Vdc If necessary, drill holes for the mounting screws in the wall or mounting box on which the reader unit will be placed. Use the template provided. Normal 110mA 1.
! If the reader has the same power supply as the door latch relay, make sure that the relay is protected by a fast Schottky diode (Part number: Philips BYV10-20). If the relay is not protected reader operation will be affected. EXTERNAL USE Mount the reader on a suitable external single gang surface mount box. Make sure that the wire bundle to the miP5 has an IP rating of at least IP67. 1. Connect the 0V Reference and 0V (if provided in the power supply) to Ground (GND). 2.
THIS PAGE LEFT BLANK INTENTIONALLY DRILLING TEMPLATE FOR miP5 Carefully remove this middle section of the manual to use as a drilling guide.
DRILLING TEMPLATE FOR miP5 20mm (0.79”) hole for wire entry 2mm x 4 mm (0.08” x 0.16”) holes for mounting screws Minimum outer dimension is 90 mm x 90 mm (3.54” x 3.
