FCC ID: QVL-BT817 Page 1of 7 APPENDIX J INSTALLATION (USER) MANUAL EMC Technologies Pty Ltd 3/87 Station Rd Seven Hills NSW 2147 Australia Tel: +61 2 9624 2777 Fax: +61 2 9838 4050
For further information or to find out more about our range of smart card and biometric solutions, visit BQT Solutions on the web at: www.bqtsolutions.com Alternatively you can contact us at one of our global locations. AUSTRALIA & ASIA PACIFIC Level 4, 65 Epping Road North Ryde NSW 2113 Australia phone: +61 (0)2 8817 2800 fax: +61 (0)2 8817 2811 email: info@bqtsolutions.
INTRODUCTION Thank you for purchasing the BT817 Mifare Contactless Smart Card Access Reader with KeyPad. ® WIRING SCHEMATIC Reader Connection The BT817 is used in security applications and interfaces into Wiegand applications. RED BLACK YELLOW/W* GREEN/W* YELLOW ORANGE GREEN WHITE BROWN/W* BROWN/W* The BT817 is preset with specific 'Keys'. Valid smart cards are issued with the same 'Keys'. This ensures that the system cannot be compromised.
WARRANTY The BT817 comes with a 3 year warranty from the date of dispatch from BQT Solutions. The warranty is void if the instructions contained within this manual have not been adhered to. See the BQT Solutions website for further terms and conditions. 30 30 Wall View SPECIFICATIONS Reader Output Wiegand 26 to 40 bit Power requirements 12Vdc Maximum Current Consumption 320mA Read range 20 - 60mm (0.8” – 2.
! If the reader has the same power supply as the door latch relay, make sure that the relay is protected by a fast Schottky diode (Part number: Philips BYV10-20). If the relay is not protected reader operation will be affected. EXTERNAL USE Mount the reader on a suitable external single gang surface mount box. Make sure that the wire bundle to the BT817 has an IP rating of at least IP67. 1. Connect the 0V Reference and 0V (if provided in the power supply) to Ground (GND). 2.
THIS PAGE LEFT BLANK INTENTIONALLY DRILLING TEMPLATE FOR BT817 Carefully remove this middle section of the manual to use as a drilling guide.
DRILLING TEMPLATE FOR BT817 20mm (0.79”) hole for wire entry 2mm x 4 mm (0.08” x 0.16”) holes for mounting screws Minimum outer dimension is 90 mm x 90 mm (3.54” x 3.