FCC ID: QVL-BT815 Page 1of 7 APPENDIX J TEST SAMPLE MANUAL EMC Technologies Pty Ltd 3/87 Station Rd Seven Hills NSW 2147 Australia Tel: +61 2 9624 2777 Fax: +61 2 9838 4050
For further information or to find out more about our range of smart card and biometric solutions, visit BQT Solutions on the web at: www.bqtsolutions.com Alternatively you can contact us at one of our global locations. AUSTRALIA & ASIA PACIFIC Level 4, 65 Epping Road North Ryde NSW 2113, Australia phone: +61 (0)2 8817 2800 fax: +61 (0)2 8817 2811 email: info@bqtsolutions.
INTRODUCTION Thank you for purchasing the BT815 Mifare Contactless Smart Card Access Reader. ® WIRING SCHEMATIC Reader Connection The BT815 is used in security applications and interfaces into Wiegand applications. The BT815 is preset with specific 'Keys'. Valid smart cards are issued with the same 'Keys'. This ensures that the system cannot be compromised. The reader incorporates a LED to provide feedback to a person wishing to enter. The LED is controlled by the security system.
WARRANTY The BT815 comes with a 5 year warranty from the date of dispatch from BQT Solutions. The warranty is void if the instructions contained within this manual have not been adhered to. See the BQT Solutions website for further terms and conditions. 30 30 SPECIFICATIONS Reader Output Wiegand Power requirements 12Vdc Wall View If necessary, drill holes for the mounting screws in the wall or mounting box on which the reader unit will be placed. Use the template provided.
! If the reader has the same power supply as the door latch relay, make sure that the relay is protected by a fast Schottky diode (Part number: Philips BYV10-20). If the relay is not protected reader operation will be affected. EXTERNAL USE Mount the reader on a suitable external single gang surface mount box. Make sure that the wire bundle to the BT815 has an IP rating of at least IP67. 1. Connect the 0V Reference and 0V (if provided in the power supply) to the Ground (GND) socket. 2.
THIS PAGE LEFT BLANK INTENTIONALLY DRILLING TEMPLATE FOR BT815 Carefully remove this middle section of the manual to use as a drilling guide.
DRILLING TEMPLATE FOR BT815 20mm (0.79”) hole for wire entry 2mm x 4 mm (0.08” x 0.16”) holes for mounting screws Minimum outer dimension is 90 mm x 90 mm (3.54” x 3.