INSTRUCTIONS FOR USE Pro-Ject MaiA DS2
Dear music lover, Thank you for purchasing an integrated amplifier from Pro-Ject Audio Systems. In order to achieve maximum performance and reliability you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse Important notice Safety instructions ! AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
1. Using front pushbutton to switch on or into standby The pushbutton on the front panel of the unit alternately turns the power on or returns it to standby mode. The blue LED on the front panel shows that the unit is powered on. If a trigger signal is present MaiA DS2 can’t be switched off by the pushbutton. 2. Remote power on - triggers MaiA DS2 can be switched on via other Box Design components when a 12V trigger voltage is present at the + 2.5mm socket marked Trigger Input.
24Bit/192kHz playback with Windows® operating systems * For Windows® operating systems a 24Bit/192kHzUSB driver (supplied on CD) has to be installed. Insert the included CD into the drive of your PC and follow the instructions. After installing the driver, some settings have to be checked/done. For example - Windows 7® operating system: Control Panel Hardware and Sound Sound Playback: select Speaker/MaiA DS2 USB 2.
Input selector After the unit is powered on, pressing the buttons◄ and input. ► next to the LEDs inputs indicators select desired Volume Adjust the volume to the desired level, using the large knob on the front panel. Connecting a headphone Connect the headphones to the ¼“ (6,3mm ) jack socket on the front of the unit. Once headphone jack is connected into the socket, rear panel outputs are muted.
! A new connection is only possible if the Pair LED is off (it indicates that no device is connected). If a problem with Bluetooth connection occurs, it is necessary to reset memory and to delete all paired devices. For reset turn off the unit > disconnect power supply > press & hold power button > connect power supply > still hold power button for another 5 seconds > release power button. The blue LED above the power button will blink for few seconds.
Replacing batteries Proceed as follows: • • Unlock and slide open the battery case cover Replace the battery. Make sure the battery is the right way round ! • Close the battery case cover Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at the appropriate collection sites - usually located at supermarkets and drugstores.
Phono input gain: S/PDIF coaxial input: S/PDIF optical input: USB input: USB data transfer: Digital to Analogue converter: Variable line level output: Fixed line level output: Subwoofer output: Bluetooth music receiver codec: Bluetooth range: Speaker terminals: Headphone output: Trigger input: MM 40 / MC 60 dB PCM up to 24bit and 192kHz PCM up to 24bit and 96kHz USB Audio Class 2 (requires USB 2.