M-1
ENGLISH Welcome to Bowers & Wilkins and M-1 Thank you for choosing Bowers & Wilkins. When John Bowers first established our company he did so in the belief that imaginative design, innovative engineering and advanced technology were keys that could unlock the enjoyment of audio in the home. His belief is one that we continue to share and it inspires every product we design. www.bowers-wilkins.
ENGLISH 1 Contents Check that you have: 1. 2. 3. Speaker on table stand Wall bracket cover Wall bracket The wall bracket and cover are supplied clipped together. Pull them apart if required for installation. If you peel off the rubber mat on the underside of the table stand, you will find a Torx key that you will need when making adjustments to the way the speaker is mounted.
ENGLISH 3 Moving the ball socket position You can skip all of Section 3 completely if you are going to use the speaker in portrait orientation on its table stand as supplied, or you want to mount it high on the wall with maximum downward tilt (Figure 7). Note: To achieve maximum tilt, it is necessary to invert the mounting of the wall bracket.
ENGLISH 4 Connecting using the table stand Remove the rubber mat from the underside of the base (Figure 15). Strip back the outer sheath of the cable by 75mm (3 in) to expose the two inner sheathed wires. Strip back the positive and negative wires to expose 10mm (3/8 in) of bare wire. If using multi-strand wire, twist the strands to obtain a neat end. Feed each wire through the appropriate hole in the back of the base, observing the polarity coding as indicated.
ENGLISH 6 Adjusting the angle of the speaker There are two screws next to the ball socket joint at the back of the speaker that tighten the joint to hold the speaker in place. It is only necessary to loosen one of these to free the joint. Indeed, in portrait orientation, only one screw will be accessible (Figure 17). Use the supplied Torx key to loosen and tighten the screws. Figure 17 7 Rotating the badge If using the speaker in landscape orientation, you will need to rotate the logo badge through 90ยบ.
