Product Manual

ManualsBrandsBounty Hunter ManualsElectronicsTracker IV Metal Detector with Pouch and Digger

OWNER’S MANUAL

1. This is a MOTION detector.

You must sweep the searchcoil from side-to-side to

detect metal.

A motionless searchcoil over a metal object will not

result in detection.

2. Do not use indoors. Detector is for outdoor use only.

Household appliances emit electromagnetic fields, which can interfere with your

detector. If conducting an indoor demonstration, turn the sensitivity down and

keep the searchcoil away from appliances such as microwaves, computers and

televisions. If your detector beeps erratically, turn off appliances and lights.

Do not test by placing coins on the floor. Most floors contain metal.

Keep the searchcoil away from floors, walls, and tables, which can contain

metal.

3. Use 9-volt ALKALINE batteries only.

Do not use Heavy Duty batteries.

Do not use ordinary Zinc-Carbon batteries.

4. Adjust sensitivity to a low level in the event of false signals

Always begin use at reduced sensitivity.

Increase to full sensitivity after you are familiar with the detector’s operation.

Important Facts to Know

about your Metal Detector.

Summary of content (16 pages)

PAGE 1
OWNER’S MANUAL Important Facts to Know about your Metal Detector. 1. This is a MOTION detector. You must sweep the searchcoil from side-to-side to detect metal. A motionless searchcoil over a metal object will not result in detection. 2. Do not use indoors. Detector is for outdoor use only. Household appliances emit electromagnetic fields, which can interfere with your detector.
PAGE 2
TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Tracker IV Features . . . . . . . . . . . . . . . . . . . . . .3 Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Batteries . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Quick-Start Demo . . . . . . . . . . . . . . . . . . . . . . . .6 Basic Operation . . . . . . . . . . . . . . . . . . . . . . .7-9 All Metal . . . . . . . . . . . . . . . . . . . . . . . . . . .7 Discrimination . . .
PAGE 3
INTRODUCTION The Tracker IV is a user-friendly instrument, requiring only a minimum of operator skill, yet delivering effective performance over a wide range of conditions and applications. Streamlined in appearance, with only two operating knobs and a mode selection switch, the Tracker IV has eliminated the two most difficult aspects of metal detector operation, Tuning and Ground Balancing. Both of these functions are automatic with the Tracker IV.
PAGE 4
EASY ASSEMBLY Assembling your Tracker IV Metal Detector is easy and requires no tools. Just follow these steps: Knurled Knob Bolt 1 Using ● the supplied bolt and knurled knob, attach the searchcoil to the lower stem. 2 Press ● the button on the upper end of the lower stem and slide the lower stem into the upper stem. searchcoil Bottom view Adjust the stem to a length that lets you maintain a comfortable upright posture, with your arm relaxed at your side.
PAGE 5
BATTERIES IMPORTANT: Always use ALKALINE batteries for optimal performance. Always remove the batteries for prolonged storage. CHECK THE BATTERIES if your detector exhibits any of the following symptoms: 1 The unit does not turn on. ● 2 Low speaker volume. ● 3 Unit beeps continuously at low sensitivity setting. ● The Low Battery indicator light will come on and stay on if the batteries are discharged. It should flash momentarily when the Power Switch is turned off.
PAGE 6
Quick Start DEMONSTRATION Here is a quick way to demonstrate the basic features of your Tracker IV. I. Supplies Needed • • • • • A A A A A quarter (25¢) nickel (5¢) Penny (1¢) small piece of aluminum foil Nail II. Position your Tracker IV • Place the detector on a table, with the searchcoil hanging over the edge. • Be sure that the searchcoil is far away from walls or metal objects. Keep the searchcoil away from any metal in the table. III.
PAGE 7
OPERATION The Tracker IV is a “motion” detector. This means that the searchcoil must be moving to detect the presence of metal. When practicing with a stationary metal detector, keep the target moving over the coil. Objects held still under the searchcoil will not be detected.
PAGE 8
OPERATION TONE MODE AUDIO RESPONSES NO RESPONSE LOW TONE BROKEN TONE HIGH TONE Iron & Steel Gold & Nickel Old & New Pull Tabs Copper, Silver & Brass TONE DISCRIMINATION (continued) (Toggle switch to the Right) Classifies detected metal objects by emitting a low or high tone. Adjust the DISCRIMINATE control higher to increase the range of the low tone.
PAGE 9
OPERATION AUTO GROUND CONTROL: The Tracker IV automatic Ground Track feature allows operation in virtually all soil conditions, regardless of mineral content. Use it effectively on the beach or for gold prospecting. In the ALL METAL Mode (Toggle switch in the middle), the Tracker IV will detect gold nuggets through black sand and will find deeply buried relics in all types of soil. OPERATING TIPS: Turn the detector on using the left knob. NOTE: The detector will remain silent when turned on.
PAGE 10
IN THE FIELD STANCE Stand with your arm extended in front of your body. Don’t bend or stoop; stand in a comfortable position. Hold the unit so that the searchcoil is about 1/2-inch above the ground. Adjust the searchcoil so that it is parallel to the ground. SWEEP Standing in the search position, swing the searchcoil gently from side to side, slightly overlapping each sweep as you move forward. Keep your searchcoil approximately 1/2-inch above the ground as you search.
PAGE 11
IN THE FIELD PINPOINTING Accurate pinpointing takes practice and is best accomplished by “X-ing” the suspected target area. 1 ● 2 ● 3 ● 4 ● 5 ● 6 ● Once a buried target is identified by a good tone response, continue sweeping the coil over the target in a narrowing side to side pattern. Take visual note of the place on the ground where the “beep” occurs as you move the coil slowly from side to side. Stop the coil directly over this spot on the ground.
PAGE 12
TROUBLESHOOTING The following troubleshooting steps may assist you in case you’re having problems with your Tracker IV. YOUR DETECTOR IS EMITTING ERRATIC SIGNALS WHEN YOU’RE IN THE FIELD. Your SENSITIVITY may be set too high. Try reducing the SENSITIVITY slightly until the false signaling disappears. Remember to swing your coil slowly. Some inconsistent signals will occur on highly rusted metals.
PAGE 13
METAL DETECTING APPLICATIONS COINSHOOTING The most popular application for metal detectors CONTROL SETTINGS REQUIRED: 1 Toggle switch to the left (disc. mode). ● 2 Discriminate knob at 3:00 (3/4 turn). ● Only silver, copper and brass will be detected. Gold items will be eliminated. Different denominations of coins will induce different sounds. RELIC HUNTING A relic is a historical object, sometimes of great value. The most effective method for locating relics is to first conduct historical research.
PAGE 14
METAL DETECTNG APPLICATIONS trash items. Gold rings will induce a low sound. Be aware that some pull-tabs can also induce a low tone. Silver will induce a high tone. Chains and necklaces are difficult to find. If you are looking for gold rings, don’t get discouraged; you will dig up many broken pull-tabs before you find your first gold ring! HOUSEHOLD APPLICATIONS Find property markers, lost keys, machine parts, and other lost items.. CONTROL SETTINGS REQUIRED: 1 Toggle switch in center position.
PAGE 15
TREASURE HUNTER’S CODE OF ETHICS: • Always check Federal, State, County and local laws before searching. • Respect private property and do not enter private property without the owner’s permission. • Take care to refill all holes and leave no damage. • Remove and dispose of any and all trash and litter found. • Appreciate and protect our inheritance of natural resources, wildlife and private property. • Act as an ambassador for the hobby, use thoughtfulness, consideration and courtesy at all times.
PAGE 16
ACCESSORIES Carry Bag Rugged double-stitched construction - CBAG-W Pouch & Digger Combo Pouch with 2 large pockets & 9” heavy duty digging tool. TP-KIT-W Bounty Hunter Stereo Headphones Use with Bounty Hunter metal detectors. Lightweight and adjustable with true stereo sound, adjustable volume, 1/8 jack with 1/4 adaptor, 4’ cable. HEAD-W Pin Pointer Pinpoints the exact location of buried metal objects. Audio signal indicator and vibrator. Runs on 1 – 9-Volt Battery.