BLUETOOTH@·ENABLED MP3·COMPATIBLE H DIGITAL MEDIA RECEIVER IN IPOD DOCKING STATION S8 AND SO MEMORY CARD PORTS AND FRONT PANEL AUX INPUT
I\)~S AUDIO SYSTEMS USER'S MANUAL 755DBI Bluetooth®-Enabled MP3-Compatible In-Dash AMIFM Digital Media Receiver with Built-in iPod Docking Station and USB and SD Memory Ports and Front Panel AUX Input Congratulations on your purchase of a Digital Media Receiver. 19» It has been designed, engineered and manufactured to bring you the highest level of performance and quality, and will afford you years of listening pleasure. Thank you for making !P.
Installation DIN front mount installation Before you begin installing your new !Sl~ receiver, please become familiar with all the information contained in this manual. For details about installing the head unit, read the instructions below and refer to the diagrams for further clarification. Before final installation of the unit, temporarily connect the wiring and make sure that the unit and system work properly.
DIN rear mount installation Removing the head unit (uses factory radio mounting bracket) Select a position on the head unit housing where the screw holes of the factory radio bracket align with the threaded screw holes on sides of the head unit (Figure 3).
iPod Dock adaptors The 755081 comes with a set of special iPod adaptors which fit a wide range of iPod models. These are specially designed for use with the 755081, and hold the iPod firmly to the dock connector when the vehicle is in motion. Please install the appropriate dock adaptor as described below. PLEASE NOTE: "Official" Apple Universal Dock Adaptors cannot be used in the 7550BI.
iPod compatibility The 755DBI and its specially-designed, included dock adaptors are compatible with a wide range of iPod types.
General and Radio Controls 71SSDBI BO~S MP3·COMPATISLE DIGITAL MEDIA RECEIVER CD AUDIO VOLUME UP/DOWN KNOB (turn) MODE SELECTOR (push) o In normal mode, use this knob to increase or decrease the volume level. VOLUME> BASS> TREBLE> BALANCE > FADER> LOUD(NESS) > EQUALIZER For Loudness, turn the knob to change it from LOUD ON to LOUD OFF. Please note: AUX IN Mode can only be selected if it is enabled in the System Settings.
using Remote Control..• CD OFF. POWER Use to turn Receiver ON or ® TUNE/SEEK (~ and m ) Press to skip ahead or back one station in tuning range of the radio band. Press and hold to seek the next station up or down the radio band. ® EQ (Preset Equalizer Curves) Press repeatedly to cycle through four o ® ® o modes: FLAT, ROCK, POP or CLASSIC. MUTE Press this button to silence the audio. Press again to restore the previous audio volume level.
USB/SD Card (MP3 Playback) Controls 1 2 3 7815D&1 MP3-COMPATIBLE DIGITAL MEDIA RECEIVER 9 To play tracks from a USB drive or SO card insert the drive into the appropriate port/slot on the faceplate. The display will show "USB U" or "CARD C," indicating that the drive is being read. The unit will display tracks when ready by file name (or, if created with ID3-tag information, with Song Title, Artist and Album information) and will begin playing the first track in the directory.
using Remote Control... 1« and »1 (Skip back/skip forward, Fast rewindlfast forward) Press these buttons to skip back or ahead one track. ® RDM (Random Play Mode) Press this button for playback of all the files in the current folder in a random order. "ROM ON/OFF" will be displayed. Press again to cancel. ® STOP Pressing STOP will stop playback. To o restart playback, press PLAY/PAUSE. Playback will begin with the first song of the current folder directory (NOT the track that was last playing).
Before removing the iPod from the dock, be sure to pause playback OR use the MODE switch to change to another mode. iPod Playback Controls 1 2 BO~S 7I5SDB. MP3-COMPATIBLE DIGITAL MEDIA RECEIVER To play tracks from an iPod, first be sure you have the proper dock adaptor inserted in the docking drawer (see instructions elsewhere in this manuaQ. Then insert the iPod. The display will show "IPOO RMT," indicating that the iPod unit has been recognized. Press PLAY/PAUSE to begin playback.
using Remote Control••. CD Fast 1« and »1 (Skip back/skip forward, rewind/fast forward) Press these buttons to skip back or ahead one track. Press and hold for fast rewind or fast forward. ® ® o ® ® RDM (Random Play Mode) Press this button for SHUFFLE playback of all songs on the iPod. Press again to cancel. PLAY/PAUSE Press to begin playback. To pause playback, press this button. Press again to resume playback. RPT (Repeat Play Mode) Press this button to repeat the playback of the current track.
System settings Settings mode You can make changes to the system settings for the 755DBI in the following areas: Radio frequency range • Enable/disable AUX input • Enable/disable iPod input Clock time format (12 hour or 24 hour) • Bluetooth enable/disable To enter the Settings mode in order to make changes, use your remote to enter the following sequence: 8, DOWN ARRO~ 9, ENTER The display will show "TEST MOD" briefly to indicate thatyou are in the System Settings area and then automatically change to Radio
Setting the clock 1 75508. MP3-COMPATIBLE DIGITAL MEDIA RECEIVER t:t.t:lX4CM1 3!2 To change the clock setting, press and hold the CLOCK button (2). The hour and minutes display will begin flashing. Setting the time After pressing CLOCK, to change the time, rotate the knob (1) to the correct time.. To switch between hour and minutes settings, press the knob. To return to normal mode, either press CLOCK or wait a few seconds.
Bluetooth "pairing" When you turn on the 7550BI, if the unit's Bluetooth system has been enabled, the display will show LINK ON/LINK OFF unless the unit has already been "paired" with another Bluetooth device like a cell phone. To "pair" the Bluetooth device with the 7550BI, enable Bluetooth on the device. The 7550BI will send a signal to the device and will appear as "CAR KIT" on the device's display and will ask you for an access code. The 7550BI's code is "DODO".
Bluetooth audio streaming Some 8luetooth-enabled cellular phones are capable of storing audio (such as music or Podcasts) and being able to send it to a 81uetooth receiver (like the 755081) for playback. These phones subscribe to a format called A2DP (Advanced Audio Distribution Profile). If your phone uses this format, and is paired to the 755081, you can play the audio stored in the phone by pressing "MODE" and selecting 81uetooth (when "8LUE" is displayed).
Wiring connection diagram Please review carefully and make connections as shown. Check all connections prior to connecting power. Please note that this unit requires +13.8V DC NEGATIVE GROUND. This receiver contains a built-in high power four-channel amplifier. To use the built-in amplifier, connect the speaker wires as shown. To use the receiver as a head unit in a mobile audio system which includes an amplifier, use the RCA outputs to connect to the LEFT and RIGHT inputs of your amplifier(s).
Troubleshooting If you experience operation or performance problems with this product, compare your installation with the electrical wiring diagram on the previous page. If problems persist, read the following troubleshooting tips which may help eliminate the problems. SYMPTOM No power. CAUSE The car ignition switch is not on. REMEDY If the head unit is properly connected to the car accessory power circuits, but the engine is running, switch the ignition key to the ':4CC" position. No sound.
IO~S Specifications AUDIO SYSTEMS 755D81 Bluetooth®-Enabled MP3-Compatible In-Dash AMIFM Digital Media Receiver with Built-in iPod Docking Station with USB and SD Memory Ports and Front Panel AUX Input RADIO Frequency ranges available BAND NAME FREQUENCY RANGE America 1 FM: 87.5-108MHz America 2 FM: 87.5-107.9MHz Europe 10 FM: 87.5-108MHz FM: 87.5-108MHz Europe 5 Mid East FM: 87.5-108MHz Aust (Australia) FM: 87.5-108MHz FM: 87.
iPod Dock Adaptors 750DI/755DBI equipped with special made iPod Dock Adapters to secure the iPod unit firmly to the dock connector while in driving condition.The iPod DockAdapters installation is as follow: ···ii!ii 4$J: ~ .• ; ( ; ! ! ' .; 1 ).Push the LCD display to open or close the iPod dock. 2).lnsert the iPod docking adaptor into the dock. Please be sure to secure the front notches into the dock first. 3).
iPod Docking Adaptors Application Guide - Ipod mode can only be selected if a IPOO is inserted.After inserting the IPOD indicator(IPOO RMT) will be displayed.
NOTE: 1.) For the safety of your property, make sure to remove your removable device (iPod) from 755081 when you are not in the vehicle. 2.) When your iPod is connected to the docking station of 755DBI and the unit is on ra.dio or AUX mode, it will not automatically power your iPod on or off. You must remember to switch the iPod on or off using the power button on your iPod. 3.
THIS PRODUCT IS WARRANTED FOR A PERIOD OF ONE YEAR FROM THE DATE OF PURCHASE AGAINST DEFECTS IN MATERIALS AND WORKMANSHIP. THE WARRANTY IS FOR REPAIR OR REPLACEMENT AT THE SOLE DISCRETION OF THE SELLING DEALER. IF WE CHOOSE TO REPLACE YOUR PRODUCT, WE MAY REPLACE IT WITH A NEW OR RECONDITIONED ONE OF THE SAME OR SIMILAR DESIGN. CUSTOMER WILL BE RESPONSIBLE FOR FREIGHT CHARGES INCURRED TO RETURN THE PRODUCT AND WILL INCLUDE A CASHIER'S CHECK OR MONEY ORDER IN THE AMOUNT OF $75.00 FOR CONTINENTAL U.S.