CONTENTS Precautions..................................................................................................................1 How to Handle Discs...................................................................................................1 Precautions & Warnings..............................................................................................1 Lithium Battery Cell Warnings.....................................................................................
PRECAUTIONS How to Handle Discs • • • • Handle a disc by its edges. Do not touch the playing side Before inserting a disc, wipe the disc outward from the disc center with a clean, soft, dry and lint-free cloth. Do not use solvents or thinners such a petrol/benzene or cleaners. After removing a disc from the disc slot, place the disc in a sleeve or case to keep it clean and prevent scratches. Do not stick paper or tape on the disc surface.
INSTALLATION Installation Opening This unit can be installed in any dashboard Having an opening as shown the right figure. 103 mm 182 mm If installation angle exceeds30 horizontal, the unit may not perform properly. To Install the Car Radio 1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle battery’s negative (-) terminal. You never want electricity running while you install this double-DIN car receiver. 2.
Electrical Connections WIRING DIAGRAM CAUTION +12V DC NEGATIVE GROUND 15A 15A 15 8. Front left PRE-AMP output (White) 9. Front right PRE-AMP output (Red) 10. Rear left PRE-AMP output (White) 11. Rear right PRE-AMP output (Red) 12. Radio antenna socket - Only use speakers with 4 ohm impedance. - Do not attach the control panel to the chassis before wiring is complete. - The maximum current of the Amp Remote trigger is 200mA.
CONTROL PANEL BUTTON LOCATIONS 19 23 22 20 21 1. (power)/Volume knob and SEL (select/menu) button 2. SRC (source) button (anser call) button 3. BAND(band) button , 4. AMS (automatic store / preset station scan, automatic music search) button 5. (pause/play), Preset station1 button 6. INT (intro) , Preset station 2 button 7. RPT (repeat) , Preset station 3 button 8. RDM (random) , Preset station 4 button 9. -10(previous 10 tracks) , Preset station 5 button 10.
GENERAL OPERATION Turn Unit On/Off • Press any button on the front panel or on the remote control to turn on the unit. • Press and hold the power ( ) button on the front panel or briefly press the power ( on the remote control to turn the unit on or off. Adjust Volume (VOL) Rotate the VOL knob on the front panel or press the VOL+ control to increase or decrease the volume level.
GENERAL OPERATION (CONT.) • Rotate the VOL knob on the front panel or press the VOL+ control to adjust the selected item. / VOL- button on the remote Set the Clock (CLK) 1. To display clock time, press the CLK button. 2. To set clock time, press and hold the CLK button and the hour will flash. 3. Press the or button on the front panel or on the remote control to adjust the hour. 4. Press the CLK button and the minutes will flash. 5.
RADIO OPERATION Switch Between USA area and Europe area Frequency In radio mode, press the VOL button to enter the switch state of the US(USA) and EU(europe) frequency, then rotate it to switch between US(USA) and EU(europe) frequency. The system will change the frequency setting in about 3 seconds. Change Bands (BAND) Press the BAND button to switch between the FM1, FM2, FM3, AM1 and AM2 bands. Each band stores up to six preset stations.
DISC / USB / SD CARD OPERATION To insert DISC / USB / SD CARD • To play files on a disc, insert a disc with the label surface facing upward into the disc slot. Playback will begin automatically. Label surface up • To play files in a USB device, open the USB port & micro SD card slot cover, then insert a USB storage device into the USB port. Playback will begin automatically.
DISC / USB / SD CARD OPERATION (CONT.
BLUETOOTH OPERATION Pair and Connect Prior to using the Bluetooth device as a handsfree system for a Bluetooth-enabled mobile phone for the first time, you must pair and connect the two devices as follows: 1. In any mode, prior to pairing and connecting, the BT logo in the LCD indicating that no device is connected. To begin pairing, enable BT mode on your mobile phone. 2. When the phone finds the car audio system, the “BOSS 660BRGB” name will be displayed. 3.
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. When the lithium cell battery becomes weak, replace it as illustrated on the right. 2. Press and hold the movable block in the direction indicated by arrow 1.
SPECIFICATIONS General Chassis Dimensions.............................................................178(W) x 160(D) x 100(H) mm Power Supply Requirement ..................................................................................DC 12V Current Consumption ......................................................................................15A (max.) Maximum Power Output ..................................................................................80W x 4CH Radio FM USA/ Europe Frequency Range.
TROUBLESHOOTING The following chart will help in solving most problems that may occur. If you still have questions after going through the checklist, please consult your local customer service representative. Before going through this check list, refer the wiring and operating procedures. Symptom Cause Solution The car ignition switch have not turn on. If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”. The fuse has been blown.