CONTENTS Precautions................................................................................................................................................. 1 How to Handle Discs.............................................................................................................................. 1 Lithium Battery Cell Warnings................................................................................................................ 1 Installation .......................................
PRECAUTIONS How to Handle Discs Handle a disc by its edges. Do not touch the playing side. Before inserting a disc, wipe the disc outward from the disc center with a clean, soft, dry and lint-free cloth. Do not use solvents or thinners such a petrol/benzene or cleaners. After removing a disc from the disc slot, place the disc in a sleeve or case to keep it clean and prevent scratches. Do not stick paper or tape on the disc surface.
INSTALLATION Prepare Radio 1. 2. Before you begin, disconnect the battery negative terminal. Remove the transport screws. 3. Remove chassis from the mounting sleeve. BRACKET KEY PLASTIC TRIM OUT BRACKET KEY If you want to remove the chassis from the mounting sleeve, remove the plastic trim out from both sides. Next, insert the two bracket keys into the left and right side of the chassis, as illustrated, to separate the chassis from the housing.
INSTALLATION (CONT.) INSTALLATION DIAGRAM DASH BOARD HEX NUT METAL MOUNTING STRAP CONSOLE PLAIN WASHER TAPPING SCREW MOUNTING SLEEVE HEX BOLT ! - Only use speakers with 4 ohms impedance. - Do not attach the control panel to the chassis before wiring is complete. - The maximum current of the auto antenna is 200mA.
INSTALLATION (CONT.) Removal of the Main Unit 1. 2. 3. Remove the metal strap from the main unit. Remove the plastic trim out from the main unit. Insert a bracket key into the left and right side of the main unit and draw the unit out of the mounting sleeve.
CONTROL PANEL BUTTON LOCATIONS 1 4 11 12 8 7 18 14 17 SRC RDM 5 MUTE 13 6 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18.
GENERAL OPERATION Turn Unit On/Off Press the power ( ) /SRC button to turn the unit on or off. Adjust Volume (VOL) Rotate the VOL knob on the front panel or press the VOL+/- buttons on the remote control to increase or decrease the volume level. Adjust Menu Options (SEL) Press the SEL button repeatedly to cycle through the following adjustable audio functions: VOL, BASS, TREBLE, BALANCE, FADER, EQ OFF, LOUD, DX and STEREO.
RADIO OPERATION Switch Between US and EU Frequency In radio mode, press and hold the VOL button to switch between US (USA) and EU (Europe) frequency. The system will change the frequency setting in about 3 seconds. Change Bands (BAND) Press the BAND button to switch between the F1 (FM1), F2 (FM2), F3 (FM3), A1 (AM1) and A2 (AM2) bands. Each band stores up to six preset stations. Manual Tuning (|<< / >>|) Press and hold the >>| or |<< button to enter manual tuning mode.
DISC/USB/CARD OPERATION Insert Disc/USB/SD To play on a disc, insert a disc with the label surface up into the disc slot. Playback will begin automatically. on a USB/SD device, open the USB port cover and To play insert the USB/SD storage device into the USB/SD port. Playback will begin automatically. Label Up SRC RDM MUTE Eject Disc/USB/SD To eject a disc, press the (stop) button to stop playback. Press the (eject) button to eject the disc and then remove it.
REMOTE CONTROL Remove Insulating Sheet The remote control comes with an insulating sheet attached to the underside of the remote control, as illustrated on the right. The remote control will not work until the insulating sheet is removed. Replace Lithium Battery Cell 1. 2. 3. 4. When the lithium cell battery becomes weak, replace it as illustrated on the right. Press and hold the movable block in the direction indicated by arrow 1.
REMOTE CONTROL (CONT.) Button Names and Locations 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20.
TROUBLESHOOTING Symptom Cause Solution No Power Car ignition not on Switch ignition key to “ACC” Fuse blown Replace fuse Disc cannot be loaded Another disc is already in the Eject disc and insert new player one Disc cannot be read Disc was inserted upside down Insert disc with label facing upward Disc is dirty or scratched Clean the disc or try to play a new one Temperature inside the car is too high Allow vehicle to cool before using player Volume turned down Adjust volume to desired leve
SPECIFICATIONS General Power Supply Requirement........................................................................................... DC 12V Current Consumption ....................................................................................................10A MAX Maximum Power Output ...........................................................................................50W x 4CH Radio FM USA/Europe............................................................... 87.5 MHz - 107.9 MHz/87.5 - 108.
0515