B2 Bass Module Owner’s Guide Guía de usario Notice d’utilitsation
Svenska Nederlands Italiano Français Español Deutsch Dansk English B2 BASS MODULE Introduction Thank you for purchasing the Bose® B2 bass module for your L1® model 1S or model II system. The L1 power stand bass module output can adequately drive one B2 bass module. A second B2 bass module can be added (to your L1 model II system only) by using a Model A1 PackLite power amplifier connected to the bass line output of the power stand.
English Dansk Deutsch Español Français Italiano Nederlands Svenska B2 BASS MODULE Connecting one B2 bass module 1. Plug one end of the B2 bass module cable into the B2 connector (Figure 3). Rotate the plug clockwise to lock it in place. Listen for a soft click to ensure the connector is locked. 2. Plug the other end of the cable into the Bass Module Out connector on the power stand. Rotate the plug clockwise to lock it.
Svenska Nederlands Italiano Français Español Deutsch Dansk English B2 BASS MODULE B2 Rear Panel The B2 bass module includes a switch allowing you to select the appropriate level of bass output for your application.
English Dansk Deutsch Español Français Italiano Nederlands Svenska B2 BASS MODULE Technical Information Dimensions: 23.4''H x 13.31''W x 18.9''D (59.4 cm x 33.8 cm x 48 cm) Weight: 45 lb (20.41 kg) Impedance: 4 ohms This product conforms to all applicable EU directive requirements. The complete declaration of conformity can be found at www.Bose.com/compliance. PackLite is a registered trademark of Bose Corporation in the U.S. and/or other countries.
©2012 Bose Corporation, The Mountain Framingham, MA 01701-9168 USA AM365142 Rev.00 www.Bose.
