Connected Products and Services Nexeed Track and Trace Sense S | Sense T User Guide Version 1.
© Robert Bosch Manufacturing Solutions GmbH, 2019. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the event of applications for industrial property rights.
Contents | 3 | 24 Contents 1 Safety Notes and Handling Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2 Hints for This Document. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3 Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
| 24 Safety Notes and Handling Information | 1 Safety Notes and Handling Information CAUTION Lithium Battery The device contains a lithium battery. Handling the battery incorrectly could cause fire. Read and follow the valid transpor‐ tation regulations. • • • • • Do not damage or cut the device. Do not dispose of the device in fire. Do not expose the device to higher temperatures than defined in this datasheet. Do not expose the device to direct sunlight.
Hints for This Document | 5 | 24 2 Hints for This Document Meaning of the used signal words DANGER! Indicates risk situations and threats to the life and health of individuals. Failure to comply with this warning can lead to life-threatening situations. • These instructions must be obeyed. WARNING Indicates a hazardous situation in which the user must act as indicated. • These instructions should always be followed.
| 24 Introduction | 3 Introduction By being attached to the asset and measuring environmental parameters such as temperature and shock events, the Sense S and Sense T sensors make the management of assets and material flow transparent and traceable. Tracking data and measured values are transferred to the Bosch IoT Cloud via Bosch Connect gateways or mobile applications.
Radio Frequency Radiation Exposure and Further Information | 7 | 24 4 Radio Frequency Radiation Exposure and Further Information The radiated output power of the device is far below the FCC radio frequency exposure limits. Nevertheless, the device shall be used in such a manner that the potential for human contact during normal operation is minimized. © Robert Bosch Manufacturing Solutions GmbH d1.0-0019-4839-1.
| 24 Technical Specifications | 5 Technical Specifications Measurement parameters Sense S Temperature, Peak Acceleration, Shock Intensity Sense T Temperature Technical data Dimension (L x W x H) 35 mm x 35 mm x 11.5 mm Weight approx.
Technical Specifications | 9 | 24 ± 1.5°C for -1°C … 13°C Time constant < 15 min for Τ63 Sampling interval 5 min Acceleration per axis ±8g Shock measurement Sense S Acceleration, three-di‐ ± 13.
| 24 Ordering Information | 6 Ordering Information Order number Sense S 3843.AU2.679 Sense S 3843.AX1.368 Sense T 3843.AU2.678 Mounting Fixture 3843.AV5.373 Mounting Plate 3843.AW1.884 For any sales information or support, please contact Bosch Connected Industry at support.tnt@de.bosch.com. d1.0-0019-4839-1.
Mounting | 11 | 24 7 Mounting WARNING The fixation must be guaranteed at all times. Do only use this device if mounting does not harm any persons or objects. • Mounting is restricted to trained personnel only. WARNING In cases of vehicles or objects exposed to high acceleration or vehicles and objects with high acceleration ef‐ fecting the device, mounting the device using magnets, adhesives, or tape is not eligible. • Mounting with screws is required.
| 24 Mounting | Mounting Fixture with Sensor on a Lattice Box (on the left-hand side) and screwed (on the right-hand side) Mounting Plate 3843.AW1.884 Mounting Plate with Sensor on a Lattice Box d1.0-0019-4839-1.
Mounting | 13 | 24 Mounting Cover 3843.AW3.380 INFO Mounting When mounting the device, consider the following information: • To enable wireless transmission, do not place the device inside metal enclosures and do not cover the device with metal. • To enable wireless transmission, do not place the device inside liquids. • Avoid positions that hinder logistics operation in a warehouse, terminal etc. • Avoid positions hotter than allowed for this device (refer to Technical Specifications).
| 24 Operation | 8 Operation The 2.4 GHz Low Energy radio is a 802.15.1-compatible wireless communication interface. The device is transmitting information packages in configurable constant intervals (e.g. every 15 s) on frequencies 2.402 GHz, 2.426 GHz, and 2.480 GHz. The RFID UHF radio interface is a battery-assisted passive wireless inferface operating at a global frequency range of 856 MHz to 960 MHz.
Dimensions | 15 | 24 9 Dimensions The following figure shows the dimensions of the Sense S and Sense T sensors. © Robert Bosch Manufacturing Solutions GmbH d1.0-0019-4839-1.
| 24 Handling and Shipping Information | 10 Handling and Shipping Information Device Sense T Order number: 3843.AU2.678 Sense S Order number: 3843.AU2.679 Battery Battery Type Lithium Metal Battery (Coin cell) Battery Model CR2032 MFR Energy Content 0.675 Wh Weight of Battery approx. 2.8 g Lithium Content < 0.25 g Transport Test according to part III, section UN38.
Handling and Shipping Information | 17 | 24 UN classification UN 3091 Lithium Metal Battery contained in equipment, 9 Special facilities Application of section II of PI 970 IATA because Lithium contained is < 2 g. Instructions IATA PI970 part II Requirements according to UN 3091 Lithium Metal Batteries contained in equipment, 9, section II of packaging instruction PI970 apply for PAX and CAO.
| 24 Support | 11 Support For any questions or inquiries, please contact Nexeed Track and Trace support at support.tnt@de.bosch.com. d1.0-0019-4839-1.
Disposal | 19 | 24 12 Disposal Disposing this product correctly will help save valuable resources and prevent any potential negative effects on human health and the environment, which could otherwise arise from inappropriate waste handling. Take into account the respective national regulations, since improper disposal may otherwise be subject to penalties. For the return of devices within the EU, follow the instructions below. Stellt der Auftraggeber eine Beschädigung bzw.
| 24 Regulatory Notes | 13 Regulatory Notes EU Declaration of Conformity Hereby, Robert Bosch Manufacturing Solutions GmbH – Bosch Connected Industry declares that the radio equipment type Sense S and Sense T is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://eu-doc.bosch.
Regulatory Notes | • • • • 21 | 24 Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. © Robert Bosch Manufacturing Solutions GmbH d1.0-0019-4839-1.
| 24 Open Source Software | 14 Open Source Software This product does not include Open Source Software. d1.0-0019-4839-1.
Intended Use | 23 | 24 15 Intended Use The Sense S and Sense T sensors are designed according to the information provided in section Technical Specifications of this document. Any use or operation which requires specific requirements and standards which are not explicitly mentioned in this document must be validated and tested on the customer’s own responsibility. The housing of the Sense S and Sense T sensors is not to be opened or tampered with.
Your feedback helps us to continuously improve our products and components. Please submit any questions, comments or suggestions for improvement via our Contacts web page. Robert Bosch Manufacturing Solutions GmbH BCI – Bosch Connected Industry Wernerstr. 51 70469 Stuttgart GERMANY https://www.bosch-connected-industry.