User's Manual

User’s manual of DL-R1024L & DL-1063L low power consumption
transmitter and receiver system
DL-R1024L is an ultra-low power receiver module with sleep function, which is very suitable
for battery powered places. DL-1063L is a matching remote controller. It adopts million code
format to prevent repeated code. It is powered by CR2032 button battery. It is very suitable for
daily use and convenient for users to replace batteries.
Using method:
1. Install CR2032 button battery on the remote controller and CR123 column battery on
the receiving module. Pay attention to the polarity of the battery.
2. Connect the output end to be controlled at the out end of the receiving module, and
install the inching safety key at the CZ1 end. When the safety key is not pressed, the
power supply of the module is disconnected, and the module can enter the next step
only when the safety key is pressed.
3. Manual output: press and hold the safety key, and then press the manual key on the
top of the module, the out end will output 0.25 seconds, each time the key is only
output once, the key time is very long, and only output 0.25 seconds.
4. Receiving switch on: press and hold the security button, and then press the learning
button in the middle of the module for 3 seconds, the indicator will flash once, the
module is in standby mode, and then it can enter the learning or remote control
operation; in the power on mode, press and hold the learning button for 3 seconds,
the indicator will flash twice, the module is in deep sleep state, at this time, it can not
be operated remotely, and the power consumption of the receiving module is close
to zero At 0.
5. Remote control learning: in the power on state, press the learning key once, and the
indicator light will be on for a long time. Press the remote control key again, and the
indicator light will flash twice continuously, indicating that the learning is successful.
Later, you can use the remote control to operate. This receiver only remembers one
remote control code. When learning a new remote control again, the code learned
previously will be cleared automatically.
6. Remote control output: in standby mode, press the remote control button, the
receiving module will output 0.25 seconds, and press the remote control for a long
time, it will only output 0.25 seconds.
7. Receiving module timing sleep: when the receiving module is in standby mode, it will
automatically enter deep sleep after 8 hours of no operation. Next time, it needs to
manually press the learning button to resume the standby mode.
DL-1063L Parameter:
1. Power supply: CR2032 button battery, standard 3VDC.