54-2101-01A.qxd 8/4/2003 1:57 PM Page 1 Pendant Speaker Model: 700286198 / 700286206 (Black) (White) Installation and Use Manual Issue 1, August 2003 © 2003 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-2101-01A 0308 Printed in Taiwan.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 2 Product Description You have purchased one of the finest pendant loudspeakers available today. Please familiarize yourself with this product by reading and reviewing the following descriptions and diagrams. These loudspeakers include a "spiderless" woofer that utilizes a high-gauss ferrofluid to guide the voice coil through the magnetic field.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 3 Product Diagrams Front Drawing 1.Tap Selection Switch 2. Coaxial Driver Assembly 3. Grille Retention Slot 4. Bass Tuning Vent (x2) 5. Perforated Steel Grille Front Drawing (grille partially shown) Rear Drawing 1. Snap-Lock Input Connector 2. Suspension Points (x3) 3.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 4 Speaker Installation If the power level is known, then select it using the front-mounted selector switch prior to installing the speaker. See section Selecting Power Levels. Speaker Grille Removal Insert a pocket knife blade between the grille and the bezel about a 1/4" deep and then gently pry the grille upwards. Do this in multiple places around the circumference of the grille to free the grille.
4-2101-01A.qxd 8/4/2003 1:57 PM Page 5 Speaker Wiring Wiring is terminated at a snap-lock input connector. There are two positive and two negative terminals to accommodate daisy chaining of speakers in a system. All wiring should be done prior to installation and then plugged into the rear of the speaker. Daisy Chaining The speaker’s snap-lock input connector allows for easy daisy chaining of speakers by providing a second terminal of each polarity.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 6 Selecting Power Levels The front-mounted selector switch is used to set the appropriate power level or impedance for your system. Using a small flat-blade screwdriver, turn the knob until the slot points to the power level you require. 70V/100V Systems Both power setting scales for 70V and 100V systems are labeled on the speakers. On the 100V scale, the last position clockwise is marked with a (not available) symbol. Do not use this position in 100V systems.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 7 Specifications SPECIFICATIONS 700286198 & 700286206 Frequency Response (-10 dB)* 60 Hz to 19 kHz LF Driver 6- /2" MDT Metal-Alloy Cone HF Driver 20 mm (3/4") Polycarbonate Dome Sensitivity (1W/1M) 89.5 dBspl (Average 100 Hz - 10 kHz) Impedance Ratings Low (16 ohms) / High (70V/100V) Power Input (Max.
54-2101-01A.qxd 8/4/2003 1:57 PM Page 8 ©2003 Bogen Communications, Inc. Specifications are subject to change without notice. www.paging-solutions.