NQ-S1810CT-G2 Nyquist Gen-2 VoIP Ceiling Speaker Installation 740-00123-00B 2006 ©2020 Bogen Communications, Inc. Specifications are subject to change.
NQ-S1810WT-G2 Nyquist Gen-2 VoIP Ceiling Speaker Installation Manual With the Nyquist Series Gen-2 VoIP Ceiling Speaker, there is no need for external amplifiers, traditional intercom wiring, or transformer taps to manually set or adjust. Connect the speaker via Cat5 to a Power-Over-Ethernet (PoE) Switch or PoE Injector, and it is ready to use.
Speaker Layout The layout of the speakers should be planned before installation begins. Layout starts in one corner of the room. The first speaker should be positioned from each wall spaced a distance approximately equal to the ceiling height of the room. The next speaker in Row 1 should be spaced a distance approximately equal to twice the height of the ceiling. Each additional speaker in the row should use this same spacing.
Mounting Equipment/Accessories RE84 Recessed Enclosure The RE84 is an optional back box for ceiling speakers. UL Listed for use where ceiling plenum is part of an air handling system, the RE84 also includes attachment tabs allowing the enclosure to be supported from structures other than the actual ceiling grid. TB8 Tile Bridge The TB8 supports the weight of the speaker and recessed enclosure. This is also the item to which the speaker mounting screws attach.
Speaker Installation (cont’d) 3. Position the TB8 over the hole in the tile and push down the locator tabs (Figure 2). Figure 2 4. Using the 4 supplied screws, attach the speaker to the TB8 Tile Bridge using the 4 clips in the corners of the opening on the TB8 as nuts. NOTE: Only tighten the screws until the grille is snug against the tile. Over tightening will cause screws to dimple the grille. 5.
Speaker Installation (cont’d) 8. Make the electrical connections using Category 5 or higher Ethernet cable with an RJ-45 connector (Figure 4). The power is supplied by PoE using an 802.3af compliant network switch or PoE injector. Figure 4 9. Place the entire assembled ceiling tile back into the ceiling grid. NOTE: Refer to the Nyquist Gen-2 VoIP Speakers Configuration Manual or the System Administrator Manual for detailed instructions on how to configure these speakers.
Compliance NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
www.bogen-ip.com • www.bogenedu.