User's Manual

Product features:
• 2.4G wireless connection with an operating range of 10 meters
• PAN3065-XY sensor for stable performance
• Three adjustable CPI settings: 800 / 1200 / 1600
• IR light-tracing technology to work on a variety of surfaces
• Energy-saving design with low power indicator
• Plug and play Nano receiving adapter
2. Move the RF mouse within 50 centimeters of the Nano receiver, reinstall
the battery, then press any key to reconnect. This operation must be completed
in 15 seconds.
3. The mouse will be ready to work after this reconnection.
Reconnection
Both the mouse and the Nano receiver have a built-in code, so you can set one
mouse to one receiver, or several to one receiver. The mouse and receiver
connection may be disrupted in cases of high temperature, high magnetic pulse,
or a strong vibration. If the connection is lost:
1. Unplug the Nano receiver from the USB port, then plug it back in.
Remarks
The data transmission uses 2.4GHz RF technology. The mouse’s working
range will be less than 10 meters if there are too many solid surfaces in the
way of the connection. The mouse does not operate well on glass surfaces.
Caution
Unauthorized amendments to the mouse are prohibited.
Before use:
1. Find the wireless mouse and Nano receiver in package
2. Plug the Nano receiver into a USB port on your PC
3. Remove the battery cover at the bottom of mouse to install one AA battery
4. LED indicator will flash for a few seconds before indicating that it’s ready to use
Product specifications
1. CPI adjustable function:
There are three CPI settings available: 800, 1200, and 1600. The factory setting
is 1200CPI. Press the left and right button of the mouse at the same time to
adjust the CPI setting.
2. Requires one AA battery
3. Power-saving mode and power switch off:
If the mouse is idle for eight minutes, it switches to power-saving mode.
Press any button to restart it. If you turn off your PC or remove the Nano receiver
from the USB port, press any button on the mouse to enter power-saving mode.
4. Nano receiver :
Small and portable, it can be plugged into the slot next to the battery position.
2.4G Wireless Mouse user manual
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions (1)this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement