User's Manual

Rev 1 – Dec 04

Wireless Gateway for Analog Telephones

Instructions

To Setup

1. Locate the SenseWear® Wireless Gateway near a telephone jack and

electrical outlet.

2. Plug the power adapter into the Wireless Gateway and into the electrical

outlet.

3. Plug the telephone cable between one of the PHONE jacks on the Wireless

Gateway and your home telephone jack.

4. If desired, you may plug a telephone into the free PHONE jack on the

Wireless Gateway.

PAGE 1
Wireless Gateway for Analog Telephones Instructions To Setup 1. Locate the SenseWear® Wireless Gateway near a telephone jack and electrical outlet. 2. Plug the power adapter into the Wireless Gateway and into the electrical outlet. 3. Plug the telephone cable between one of the PHONE jacks on the Wireless Gateway and your home telephone jack. 4. If desired, you may plug a telephone into the free PHONE jack on the Wireless Gateway.
PAGE 2
Operating Instructions 1. Take a reading using a SenseWear® Biometric Transceiver enabled device. 2. The RECEIVE light will blink when readings are received. 3. A tone can be heard when valid readings are accepted by the Wireless Gateway. 4. The POWER light will blink when the Wireless Gateway is using the phone line to upload your data to your monitoring service. 5. If it is unable to upload your data, it will retry periodically until successful. 6.
PAGE 3
Certifications Disclaimer This product is not intended to be a medical device or a substitute for proper medical diagnosis, care, or treatment related to your condition. Seek professional consultation if you have any questions related to the readings provided by this product. FCC statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.