Specification Sheet
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 4/20/17 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2017 by Bobrick Washroom Equipment, Inc.
Technical Data
MATERIALS:
Tubing — 1" diameter, 20 gauge stainless steel, seamless construction with exposed surfaces in architectural satin finish.
Swivel Brackets — Chrome-plated zinc die-cast construction with exposed surfaces in architectural satin finish. Maximum 55 degree
swivel rotation.
INSTALLATION:
Place pivoting mounting bracket assemblies onto ends of curved shower curtain rod the same distance each end, with set screw bosses
oriented in the downward direction. Insert set screws (2) provided by manufacturer into set screw bosses and thread them in loosely.
While holding curved shower curtain rod assembly in final desired mounting location, securely tighten set screws, with Allen wrench
provided, to retain pivoting mounting brackets to rod, and mark desired locations of pivoting mounting brackets on walls.
Disassemble wall mounting plate portions of the mounting brackets by removing the Phillips-head screws (2 each) from the top and
bottom of the bracket assemblies.
For plaster or drywall construction, provide concealed backing to comply with local building codes, then secure mounting plate
portion of mounting brackets to walls in marked locations with #8 x 1-1/2" (38mm) Phillips-head screws (4) provided by manufacturer.
For other wall surfaces, use fiber plugs or expansion shields for use with screws furnished, or provide 1/8" (3mm) toggle bolts or
expansion bolts.
Position curtain rod assembly in place and secure pivot sections of mounting brackets to mounting plates by replacing the Phillips-head
screws (4) at top and bottom of mounting brackets.
SPECIFICATION:
Shower curtain rod shall be 20-gauge (1.0mm) stainless steel with satin finish. It shall have an outside diameter of 1" (25mm). Swivel
Brackets shall be chrome-plated zinc die cast construction with exposed surfaces in architectural satin finish.
Curved Shower Curtain Rod shall be Model B-4207 x ______________ (insert length) of Bobrick Washroom
Equipment Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom
Equipment Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick
Washroom Equipment Limited, United Kingdom.
B-4207
SERIES
CURVED SHOWER
CURTAIN ROD
Finish Face of Wall
to Finish Face of Wall
9"
229mm
1"
25mm
74-1/2" 1892 mm
Standard Mounting Height off Floor
for 72" Bobrick Shower Curtain and Hooks
B-4207 x 60 60" 1524mm
B-4207 x 72 72" 1829mm
Model
Number
"A"