Specification Sheet

The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet. Revised 5/06 Printed in U.S.A.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions. © 2006 by Bobrick Washroom Equipment, Inc.
Technical Data
S
S
2-1/2''
65mm
Ty p.
3-3/16''
80mm
Shelf
16''
405mm
Spindles
S
S
9-11/16''
245mm
1/2''
13mm
Ty p.
1/2''
13mm
5''
125mm
Finish Face of Wall
S
S
3-7/8''
100mm
Recommended Mounting Height Off Floor
for Universal / Accessible Design
22''
560mm
SURFACE-MOUNTED
TOILET TISSUE DISPENSER
AND UTILITY SHELF
MATERIALS:
Shelf — 18-8, type-304, 20-gauge (1.0mm) stainless steel with satin finish. 1/2" (13mm) return edges for maximum rigidity. Front edge
is hemmed for safety.
Mounting Brackets — 18-8, type-304, 18-gauge (1.2mm) stainless steel with satin finish. Welded to shelf.
Toilet Tissue Dispensers (2) — Support brackets are 18-8, type-304, 18-gauge (1.2mm) stainless steel with satin finish. Equipped
with two chrome-plated plastic spindles, each with a heavy-duty internal spring.
OPERATION:
Close clearance of support brackets deters removal of toilet tissue rolls until they are depleted. Unit holds two standard-core toilet
tissue rolls up to 5-1/2" (140mm) diameter (1800 sheets).
Designer’s Note: It is recommended that one full toilet tissue roll remain wrapped or taped until the other roll has been depleted to avoid
wasting the ends of both rolls.
INSTALLATION:
Mount unit on wall or partition with four #7 x 1-1/2" (3.8 x 38mm) sheet-metal screws (not furnished) at points indicated by an S.
For partitions with particle-board or other solid core, provide sheet-metal screws or through-bolts, nuts, and washers.
For hollow-core metal partitions, provide solid backing into which sheet-metal screws can be secured. If two units are installed back-to-
back, then provide threaded sleeves and machine screws for the full thickness of partition.
For plaster or dry wall construction, provide concealed backing to comply with local building codes, then secure unit with #7 x 1-1/2"
(3.8 x 38mm) or longer sheet-metal screws.
For other wall surfaces, provide #7 x 1-1/2" (3.8 x 38mm) sheet-metal screws and fiber plugs or expansion shields, or provide 1/8"
(3mm) toggle bolts or expansion bolts.
SPECIFICATION:
Surface-mounted toilet tissue dispenser and utility shelf shall be type-304 stainless steel with satin finish. Shelf shall have 1/2" (13mm)
return edges with front edge hemmed for safe handling. *Spindles shall be chrome-plated plastic with heavy-duty internal spring and
shall hold standard-core toilet tissue rolls up to 5-1/2" (140mm) diameter (1800 sheets).
*Theft-resistant spindle (part No. 283-604) available as a replacement part.
Surface-Mounted Toilet Tissue Dispenser And Utility Shelf shall be Model B-2840 of Bobrick Washroom Equipment,
Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick Washroom Equipment Company,
Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and Bobrick Washroom Equipment Limited,
United Kingdom.
B-2840