Bobcat Miner 300 USER MANUAL
Contents Bobcat Miner 300 1. 2. 3. 4. 5. 6. 6.1 6.2 7. 8. 9. USER MANUAL ................................................................................... - 1 - Introduction ............................................................................................................................... 1 Network Systems ...................................................................................................................... 1 Specifications ...................................................
1. Introduction Bobcat Miner 300 is a Bobcat IoT hotspot device, which is compatible with Helium LongFi, which combines the leading wireless LongFi protocol and helium blockchain technology. Bobcat Miner 300 is also compatible with all LongFi devices. Bobcat Miner 300 operates with ultra-low power consumption (5W) and its signal range, can cover more than 10 miles, and provide connections to thousands of LongFi end nodes detected within its range. 2.
3. Specifications Model LongFi Specifications Frequency Bobcat Miner 300 Channel Capacity US915: CH 09 AS923: CH 10 Half duplex ≤50mW Work model Output Power Platform Configurations Flash RAM CPU WIFI BT GPS Connectors Antenna Ethernet Power Buttom Physical Description Dimensions(L*W*H) Chassis Type Color Environmental Operating Temperature Storage Temperature Relative Humidity Heat Dissipation US915:902-928MHz AS923:919-925MHz 64GB eMMC 5.1 1GB DDR3 Quad-core A35 802.11 b/g/n WLAN BT5.
4. Interface description 5. LED Indicator Description The different colors of the LEDs represent different working states of the gateway. Indicator color Yellow Red Indicator status Description The gateway is in standby mode The network is not connected The gateway power-on initialization status Green The gateway is configured and The network connection is operating normally. Blue Bluetooth is activated, can be Press BT BOTTUM for 5s to scanned and connected activate --- 6. normal.
.2 Configure network connection 6.2.1 Equipment assembly Open the package, take out the device, power adapter and antenna, insert the SMA male connector of the antenna feeder into the LongFi antenna port of the device and tighten it. 6.2.2 Set up distribution network Open the Helium App in your phone, register to enter, and select "Set up Hotspot".
1) Insert a pin into the BT BUTTON hole and press the button for 5 seconds, and then watch the LED turn blue to start Scan. After scanning the device, click to enter the next step; 2) If you use wifi connection, select the wifi router around Scan, select the name of the wifi router you need to access, and output the password. 3) If you use Ethernet connection, select "Use Ethernet Instead" at the bottom of the page and insert the network cable.
7. Structure size 8. Package Content 9. Installation guide Bobcat IoT hotspot devices support three conventional installation methods: Desktop type: Place the gateway and power supply on a horizontal plane and adjust the antenna direction, which is suitable for temporary demonstration and debugging.
Wall-attached type: Hang the gateway on the wall through expansion pipes and screws for fixed installation, and adjust the antenna direction flexibly.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.