Lid Ro @ Master power switch @ LCD Display Q@ Push Buttons @ 4 Always ON output Indicator (® 4 Timed output Indicator
@ Master Power Switch @ LCD Display: Indicates current time and output state. @ Push Buttons @ 4 Always On output indicator ® 4 Timed output Indicator ® Sockets: Intended to be used with grounded device only.
A LES 1. Charge the Internal battery If the screen Is blank, plug the timer Into any outlet for 30 minutes to charge the internal battery. Rests the timer Press the “RESET” button with the tip of a small non-metallic insulated tool, such as a pend ll or toothpick. LCD display will tum on. » = Unplug and program timer ‘With a charged battery, you can now set the timer up at the comfort of your char.
Example: If It Is 7:30am Friday, please follow below steps to set the current day and teems. 1. Press and hold the “CLOCK” button, then press the “WEEK” button unt °Fr” displays on top of the screen. (Fig 01) 2. Press and hold the “CLOCK” button, then press the "HOUR" button until 7:00am displays on the screen. (Fig 02) Soto: please pay attention to AM/PM. 3. Press and hold “CLOCK” button, and press “MIN” button until 7:30 am displays on the screen.
Press the “HOUR” button until 8:00 am displays on the screen. (Fig 06) 4. Press the "MIN" button until 8:05 am displays on the screen. (Fig 07) 5. Press the “PRIG” button once to set program “1 OFF" you will see the picture. (Fig 08) 6. Repeat steps set program “1 OFF". {Fig 08) 7. If you want to set the second ON/OFF program, press “PRIG” button again, you can repeat steps set program, or press the “CLOCK” to rectum the current time. Press “R" button in any program to erase the program.
timer. To do so, Just repeat steps 1 to 6 for program “2 ON" “2 OFF" “3 ON" of. 8. Once you have set the programs, make sure you're in AUTO mode so that the timer will run your programs. D. SWITCHING BETWEEN MANUAL/AUTO MODES OVERRIDING PROGRAMS/MANUAL TURN ON/OF To run your programs, your mire must be In AUTO mode. You can tell which mode the timer is currently in by checking if AUTO or MAN Is present below the current ime.
|| SET RANDOM FOR VACATION SECURITY In order to use the random function, you must set at least 1 set of programs. Pressing the “WEEK” and “HOUR” buttons simultaneously will activate security mode. “RND" will be shown to the right side of the display. ‘When the timer Is working In Auto mode and the random function is on, the previously programmed ON and OFF times will be separately postponed by 2-32 minutes. NOTE: A timer program shall be 33 minutes or longer for the random function work properly.
Fa 11) DST OFF (Fig 12) DST ON (Fp 12) ASTON TROUBLESHOOTING Timer does net tum on or off. a. Make sure AM and PM are correct on the current time and in the program tastings. b. Timer program should be on AUTO setting. ©. Make certain that both an ON and OFF time have been specified. d. Kf the number Is not clear or blank on the screen, please plug the timer into any outlet for 30 minutes to charge the internal battery, then press the Reset button. .
CENTURY PRODUCTS INC. 3545 Granada Ave El Mont Ca 81731 Custom Service Assistance: 1.