DA44AU User Manual RevA3_User_Manual_DA44AU
DA44AU USER MANUAL Contents Thank you for purchasing this product. Introduction 03 For optimum performance and safety, please read these instructions carefully before connecting, operating or adjusting this product. Please keep this manual for future reference. Features 03 Panel Descriptions 04 Audio Input Settings 05 Dante® Controller Surge protection device recommended.
DA44AU USER MANUAL Introduction Our DA44AU is a four input / four output Dante® digital audio converter. The DA44AU allows any non-Dante® audio source such as mixing consoles, amplifiers, computers and Blustream Matrix products or distribution products to be connected as an audio source within a Dante® network, as well as converting a Dante® signal back to an analogue audio signal. The DA44AU supports both balanced and unbalanced audio as well as microphone line level inputs inc. 48V phantom power.
DA44AU USER MANUAL Front Panel 1 3 4 2 5 6 7 8 9 10 1 Power Indicator LED - Illuminates when the unit is powered on 2 Input Indicator LED - Illuminates when an analogue audio signal is detected on the associated input into the unit 3 NET Indicator LED - Illuminates when the unit is receiving a Dante® network audio signal and audio is output 4 Link Indicator LED - Illuminates when the unit is connected to PC configuration software 5 48V Phantom Power Indicator LED - Illuminates when 48V phantom po
DA44AU USER MANUAL Audio Input Settings The DA44AU supports both line level input and microphone input including 48V phantom power. The input level sensitivity can also be adjusted to accomodate various source devices. This can be achieved through the front display menu, using the rotary dial, or via RS-232.
DA44AU USER MANUAL Dante® Controller By default the DA44AU is shipped with its network settings set to obtain an IP Address automatically. This means that if a DHCP server is present on your network, it will provide the DA44AU with an IP Address. If no DHCP server is present then the DA44AU will receive a default IP Address in the 169.254.xxx.xxx range. To change the IP Address of the DA44AU, you must enter the “Network Config” menu in the “Device Info” screen of the Dante® Controller software.
DA44AU USER MANUAL Example Schematic DA44AU Cat 6 Analogue Audio RS-232 1G Network Switch 4 x Mono | 2 x Stereo Outputs Recorder Laptop | Dante® Controller Dante® Controller 4 x Mono | 2 x Stereo Inputs 07 contact support@blustream.com.au | support@blustream.co.
DA44AU USER MANUAL RS-232 Control Port The DA44AU can be controlled via a 3-pin Phoenix to serial RS-232 cable.
DA44AU USER MANUAL Specifications Audio Input Connectors: 12-pin Phoenix connector (4ch balanced / unbalanced analogue audio / MIC) Audio Output Connectors: 2 x RJ45, female (1Gb Dante® network), 12-pin Phoenix connector (4ch balanced / unbalanced analogue audio / MIC) Dante® Audio Technology: Dante® Ultimo Casing Dimensions (W x H x D): 215mm x 44mm x 145mm without feet Shipping Weight: 1.
DA44AU USER MANUAL Installer Notes: 10 www.blustream.com.au | www.blustream.co.
DA44AU USER MANUAL Installer Notes: contact support@blustream.com.au | support@blustream.co.
www.blustream.co.uk www.blustream.com.
