User's Manual

ManualsBrandsBlupont ManualsElectronicsPCI 11N 300 MBPS 2X ANTENNA

Wireless Network Card Installation Guide

System Requirements

● One available PCI 2.0/2.1/2.2/2.3 port

● One available USB 1.1/2.0 port

● Operating System: Windows ME/2000/XP/Vista/win7

● Minimum Disk Space: 2MB

Software Installation

You must have the following information available before installing your

Products

1. Wireless Network Name (SSID) and,

2. Encryption/Network Key (if applicable)

Note: Screen-shot images provided below is based on Windows Vista. You may

see different screen on other operating systems but procedures are the same.

CAUTION: Products should NOT be inserted at this time. You will be asked to insert after the

software is completely installed.

A. Power on your computer and allow Windows 2000/ME/XP/Vista/Win7

to load fully.

B. Insert the installation CD to your CD-ROM and run “Setup.exe” program.

“Ralink Wireless LAN – InstallShield Wizard” will appear on your screen,

select “I accept the terms of the license agreement” then click “Next.”.

Summary of content (4 pages)

PAGE 1
Wireless Network Card Installation Guide System Requirements ● ● ● ● One available PCI 2.0/2.1/2.2/2.3 port One available USB 1.1/2.0 port Operating System: Windows ME/2000/XP/Vista/win7 Minimum Disk Space: 2MB Software Installation You must have the following information available before installing your Products . 1. Wireless Network Name (SSID) and, 2. Encryption/Network Key (if applicable) Note: Screen-shot images provided below is based on Windows Vista.
PAGE 2
C. Click “Install” to begin the installation and it will copy all necessary files to your hard disk automatically. D. Click “Finish” when you see “InstallShield Wizard Complete” to finish the installation.
PAGE 3
You will see “Configuration & Monitor Utility” icon appears on your system tray when the installation is completed successfully. If you don’t see the icon, we highly recommended you to restart the computer. However, if you still don’t see the icon appears, please uninstall and reinstall the software again. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules.
PAGE 4
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.