VOICE Dual mic noise cancellation bluetooth® headset User guide Enjoy the ultimate voice control headset. You only need to say. No voice training required.
English Get started... ∙ Fully charge your headset for 2 hours. ∙ Select the ear bud and ear hook that fit for your ear. ∙ Wear the headset. ∙ Press the main button for 5 sec. You will hear the welcome message : “Hi, Welcome to the Bluetrek Crescendo headset with the BlueGenie Voice Interface. To get started you’ll need to pair your headset. Click the main button to enter pair mode.” ∙ Follow the instruction, press the main button to entry to the pair mode.
English Special Commands to access FREE service in USA You can say “Call Information” to search for local and business listings with Bing™ 411. Find news, directions, restaurant locations, weather forecasts, movie showtimes, and more. You can say “Traffic Conditions” to connect to local 511 services to check traffic condition in USA. For example, road work, traffic jam, accident information etc...
The following is a comprehensive list of the available commands. At any time you can use the “What Can I Say” command to listen the available commands. Command Say this to...
English Call Voice mail/ Favorite 1 Call number preset on Speed Dial 1 Call Favorite 2 Call number preset on Speed Dial 2 Call Favorite 3 Call number preset on Speed Dial 3 Call Favorite 4 Call number preset on Speed Dial 4 Call Favorite 5 Call number preset on Speed Dial 5 Call Home Call number preset on Speed Dial 6 Call Office Call number preset on Speed Dial 7 Traffic Conditions Connect to local 511 center for Traffic conditions Answer Answer the incoming call Ignore Reject the incom
BLUETREK Crescendo supports multipoint technology, which allows you to use one headset with two different Bluetooth mobile phones. Please see the instructions as below: Enable the multi-point function 1. Pair the headset to the mobile A (Please refer to “pairing” section). 2. Long press the Vol + and the Vol - button together on the headset under stand-by mode, when heard a “beep”, release the buttons and you will hear “Multi-point on” prompt to finish, the multi-point function will be enabled. 3.
English Disable the multi-point function Long press the Vol + and the Vol - button together on the headset under stand-by mode, when heard a “beep”, release the buttons and you will hear “Multi-point off” prompt to finish, the multi-point function will be disabled.
Under setting menu, you can set. “Say a command prompt “- Enables or Disables the “Say a command prompt”. With it disabled, you will hear a beep instead of voice command. ∙ Incoming call announce - Enables or Disable the Incoming call ID prompt and voice answer functions (this function may not available on some phones). ∙ Save favorite - A phone number can be saved on the headset after you received an incoming call. ∙ Voice control help ∙ Turn off voice control - Turns off the voice control.
English Control the headset by button Function Button Time Status Power On Main button 5 sec From off Power Off Main button 7 sec From on / Standby Enter Pairing Mode Main button 7 sec From off Activate Voice control Main button Press once Idle / Pairing / Standby Answer Call Main button Press once Ringing Reject Call Main button 3 sec Ringing End Call Main button Press once Active call Redial Main button Double click Standby (Connected) Volume adjust Vol + / Vol - Pres
This user manual is just to get you started. If you are having trouble, visit www.bluetrek.com to download the user manual , which has full details of all features and functions. Features may vary depending upon your mobile phone . You can check the compatibility on our website. You can also check with your phone manufacturer that your handset supports either handsfree or headset Bluetooth profiles. Visit our website and check for available firmware updates.