User's Manual

BlueSecure™ Access Point 1800 Installation Guide
24
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This device and its antenna(s) must
not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC /IC Radiation Exposure Statement:
This equipment complies with FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
If this device is going to be operated in 5.15 ~ 5.25GHz frequency range, then it is restricted in indoor
environment only.
Ant. Antenna
Type
Model Name Product description Gain (dBi) Tx/Rx
mode
REMARK
4
PIFA
Antenna
TFF-Z016MPXX-361 Integrated PIFA Antenna 4.98/5.08
2T3R
concurrent
Main Ant. for test
Ant.
Antenna
Type
Model Name Product description Gain (dBi)
Tx/Rx
mode
REMARK
1 Monopole Ant. TWX-145XRSXX361
2dBi 2.4/5GHz Dual-Band
Antenna
2/2
2T3R
concurrent
Main Ant. for test
2 Monopole Ant IWX-145XRSCX-361
2dBi 2.4GHz Single-Band
Antenna
2
2T3R
concurrent
N/A
3 Monopole Ant KWX-145XRSDX-361
2dBi 5GHz Single-Band
Antenna
2
2T3R
concurrent
N/A
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (EIRP) is not more than that required for successful communication.
This device has been designed to operate with an antenna having a maximum gain of [5.08] dBi. Antenna having a
higher gain is strictly prohibited per regulations of Industry Canada. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.