HOT SWAP SYSTEM FOR V-LOCK LITHIUM ION BATTERIES Model MVQUICK OPERATING INSTRUCTIONS Revision 1.2 www.blueshape.
Introduction MVQUICK is a hot swap system to be installed as a battery interface between the camera (or any other V-lock compatible device) and the battery pack. The main purpose is to allow camera battery replacement without any power interruption through an automatic detection of the battery removal. Additionally, MVQUICK provides an alternative power source of about 21Wh to be used as UPS in case of a sudden power failure or extended power requirements. MVQUICK graphic description 1 2 3 5 4 2 1.
Principle of operation MVQUICK features an internal battery system of about 21Wh. This power source is automatically connected to the output terminals (becoming the only power source) whenever the main V-Lock battery is not installed, removed or empty (voltage below 12V). Alternatively, when a V-Lock battery with a voltage greater than 12V is installed, it becomes the main power source connected to the output connector.
How to check the state of charge Out from the box, the internal battery of MVQUICK has a state of charge of about 50% or higher. To verify the state of charge: When the external battery is installed: Press the “Check” button to verify the state. The LED will stay on for about 3 sec showing the state (see table above). The LEDs will flash when the internal battery is being charged. - When the external battery is not installed: The LEDs are automatically alighted continuously displaying the state of charge.
This automatic partial charging is an efficient way to keep MVQUICK fully charged even after several swaps. It is however recommendable to fully charge MVQUICK on a charger for the first time, or prior to an extensive working session. How to switch off / switch on MVQUICK is supplied switched off to save internal power and automatically enters in low power mode when not in use. - How to switch it on: a) MVQUICK automatically switches on upon installation of an external battery with a voltage > 12V.
Battery communication bypass When MVQUICK is used with BLUESHAPE V-lock batteries or with batteries having the same communication protocol, it is possible to obtain data communication between the device and the battery. The data switch selector can be moved by a pointed object towards ON to enable or towards OFF to disable data communication. Technical specifications Internal battery: Type Nominal voltage Nominal capacity Max. discharge current Li-Ion rechargeable 14.4V 1.
Warranty BLUESHAPE MVQUICK is warranted to be free from defects in materials, workmanship and functionality for a period of 18 months commencing from the date of purchase. This warranty shall not apply to any products or parts of, that have been subjected to misuse, negligence, accidental or abnormal conditions of operation. The buyer should always contact the place of purchase for any return of defective product.
NEW CELL TOP Srl VIA LIGURIA 4-6, 42124 REGGIO EMILIA, ITALY TEL. +39 0522 518556 FAX. +39 0522 277084 WEB: www.blueshape.net EMAIL: info@blueshape.