User's Manual

Paper
Microsoft usb
Packing List
Installation Guide
P10 Printrer Quick Installation Guide
Load Paper Charge printer
Bluetooth LED Status Code
Power Key
Funtion Key
Feed Key
Light guide
Part List
LED Error Code
Caution& FCC/CE Statement
Constantly lit
Flashing Constantly lit Constantly lit
Off Flahsing together
Bluetooth module available Data transaction Via Bluetooth Power on normal status Charging Charging finished
An error has occurred (see Error Code)
Out of paper
A transmission error occurred
Print head overheated
Battery voltage is too low
Add paper
Check the tansmission status
Wait untill the print head cools down
Recharge the battery
FCC Compliance Statement “This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ࠉ Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.
WARNING: 'RQRWGLVDVVHPEOHWKH3ULQWHUEDWWHU\ Only qualified technicians may service the device. 'RQRWXVH3ULQWHUQHDUZDWHU
1. Use desk and mobile PC USB port connect into micro USB of the printer 2. When charging the LED will be red, when the battery is fully charged, the LED will turn off. Note: Don’t provide AC adapter for P10
Insert plug here
Device name and PIN Ɣ'HYLFHQDPHDQG3,1ODEHOFDQEHIRXQGXQGHU the paper roll Discovery Modes (factory set) Ɣ$OZD\V$OZD\VGLVFRYHUDEOH ƔVW&RQQHFW'LVFRYHUDEOHXQWLOVWFRQQHFWLRQ is established Ɣ0RGH.H\3UHVV0RGH.H\WRPDNHGLVFRYHUDEOH for 90 seconds Using with Apple devices Ɣ3UHVV0RGH.H\WZLFHWRGLVFRQQHFWDQGSUHVV twice again to reconnect Ɣ%OXH/('ZLOOIODVKZKHQFRQQHFWLQJGLVFRQQHFWLQJ from Apple devices Ɣ6XSSRUWVL26DQGKLJKHU
FCC Compliance Statement Increase the separation between the equipment and receiver. ࠉ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ࠉ&RQVXOWWKHGHDOHURUDQH[SHULHQFHGUDGLR79 technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
EU Regulatory Conformance
(XURSH577( &RPSOLDQFH6WDWHPHQW+HUHE\%OXH%DPERR declares that this equipment complies with the essential requirement and other relevant provision RI'LUHFWLYH(&2)7+((8523($1 3$5/,$0(17$1'7+(&281&,/RI0DUFK 1999 on radio equipment and telecommunication terminal equipment and the mutual recognition of WKHLUFRQIRUPLW\577( CE NB Mark:
For warranty period,repair and service issues,please contant your distributor:
Caution& FCC/CE Statement