BLU ARIA POD Quick Guide
Dual-ear mode: Initial use of headsets When using the headsets for the first time, take the left and right headsets out of the charging box, remove the film, and put the two headsets back to the charging box. The blue indicators of the two headsets are on, and the headsets are activated. Basic Operations Auto power-on/off: When the headset is taken out of the charging box, the headset is automatically powered on and the TWS connection is successfully established, accompanied by a voice prompt.
Connection: When taken out from the charging base, the headsets are automatically powered on,and enters pairing status. Search for the pairing target name on your mobile phone, tap Connect, and an electronic prompt tone rings. Apparel Please follow the diagram to penetrate the earphone into the ear, press the R<> right ear and LRR<> ear correspondence. Please rotate the headset slightly and adjust to a comfortable angle to ensure that the headset is stable and tight to prevent the headset from falling off.
Hang-up: During a call, press the MFB button on the left/right channel headphone once. A beep is prompted. Rejecting a call: When a call comes in, double press the MFB button on the left/right channel headphone. A beep is prompted. Audio transfer: During a call, long press the MFB button on the left/right channel headphone, and release until a beep is prompted. Repeat this operation to transfer the audio between your phone and headset.
Three-way call: During a call, if another call comes in, Press the MFB button on the left/right channel headphone once to hang up the current call and answer the incoming call. - Double press the MFB button on the left/right channel headphone to keep the current call (A) and answer the incoming call (B). Double press the MFB button again to switch between calls A and B. - During a three-party call, press the MFB button on the left/right channel headphone once to hang up the current call.
Anti-lost alarm: When the headset is far away from you or is abnormally disconnected, a voice prompt can be heard. 5 minutes later, the headset will be automatically powered off. Charger and Battery Before using any charger to charge this earphone, check whether the specifications of the charger meet requirements. The recommended output voltage of the charger is DC5V+/-0.25V, and the recommended output current is 100 mA to 500 mA. An over-high charging voltage may damage the earphone.
1.When the LED indicator connected earphone flash red with a voice “please charge”, put the earphone into the charging box. Otherwise the earphone will power off automatically. 2.If both the earphone and charging box are out of power, insert the cable of the charger into the Micro-USB port on the charging box, and plug the charger into the AC socket. The charging box and earphone will be charged simultaneously. 3.
FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement.