Installation Instructions

ARIA POD MINI

BASIC OPERATION

Auto Power On/Off: When the earbuds are taken out of the Battery-powered Case, the earbuds

will automatically power on.

When the earbuds are placed into the Battery-powered Case, the earbuds will automatically

power off and enter charging mode.

Automatic Reconnection: After the earbuds are powered on, they are automatically reconnected

to the last paired device.

1. Earbuds

2. Multifunction Button(MFB)

3. Charging Contacts

4. Microphone

5. Speaker

6. Indicator Light

7. Charging Connector

8. Battery-powered Case

Binaural Function:

Answer a Call: When there is an incoming call, click the left or right MFB to receive the call.

Hang-up a Call: During a call, click the left or right MFB to terminate the call.

Incoming call rejection: When there is an incoming call, Press and hold the left or right MFB for 3

seconds

Music Play/Pause: When the music is being played, click the left or right MFB to pause the music.

Repeat the step to restart playing music again.

Previous Track: double tap the left

Next Track: double tap the right

Volume increase: Press and hold the right MFB for 3 times

Volume reduction: Press and hold the left MFB for 3 times

Power On/Off: Long press to power off and disconnect

FCC Caution.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

PAGE 1
ARIA POD MINI BASIC OPERATION Auto Power On/Off: When the earbuds are taken out of the Battery-powered Case, the earbuds will automatically power on. When the earbuds are placed into the Battery-powered Case, the earbuds will automatically power off and enter charging mode. Automatic Reconnection: After the earbuds are powered on, they are automatically reconnected to the last paired device. 1. 2. 3. 4. 5. 6. 7. 8.
PAGE 2
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.