Instructions / Assembly

ManualsBrandsBloem ManualsGarden CenterBlack Hanging Garden Plastic Planter System (3 pack)

Hanging

Set-up

Hanging Garden System

Installation Instructions

The Fiskars

Hanging Garden System can be displayed as individually hanging planters (directions on next page) or with up to three

planters linked together vertically (directions below). Determine how you will hang your planters and follow the appropriate directions.

1. For best results when planting, ﬁll

the planters with potting mix that

will hold the right amount of

moisture to help your plants grow.

Place plant(s) toward the front of

each planter to ensure access to

the sun, but leave enough room

for the plant to grow.

2. Position the top planter in the

location you want it to hang,

referring to the other side of this

card for the proper ratio of sun to

shade for your plants. Starting at

the top of the back side, loop a

stainless-steel fastener through

the hole on the top of the planter,

around the steel rod and wrap

around your deck rail or fence.

Feed the fastener through the

locking end, tighten until planter

is snug. Repeat on other side.

Hint: If displaying the system on a wood

deck railing, consider placing a protective

liner or pad between the metal fasteners

and the deck railing to prevent the

fasteners from digging into the wood.

3A:

Hang planters

by linking vertically

1: Install self-watering inserts

Press down firmly until the insert

snaps into place over the attachment

posts. The tops of the posts will be

visible above the insert. Repeat for all

three planters.

2: Install steel rods

Turn the planter upside down and face

the back. Slide the steel rod into the slot

behind the rim, between the two

dividers (see inset below). Press firmly

until it snaps into place. Rods are

inserted correctly if they cannot be

moved from side to side or lifted out

easily. Repeat for all three planters.

Soil line

3. Trim excess fastener using a

hardware snip.

4. Attach the middle and bottom

planters as shown below. Pull the

upper planter out and lift the lower

planter into place so the metal rods

go up and over the built-in plastic

hooks on the bottom of the planter

above.

Summary of content (2 pages)

PAGE 1
Hanging Garden System Installation Instructions Set-up 1: Install self-watering inserts 2: Install steel rods Press down firmly until the insert snaps into place over the attachment posts. The tops of the posts will be visible above the insert. Repeat for all three planters. Turn the planter upside down and face the back. Slide the steel rod into the slot behind the rim, between the two dividers (see inset below). Press firmly until it snaps into place.
PAGE 2
3B: Hang planters individually Soil line 1. For best results when planting, fill the planters with potting mix that will hold the right amount of moisture to help your plants grow. 2. Position the top planter in the location you want it to hang, referring to the other side of this card for the proper ratio of sun to shade for your plants.