Blockstream Jade v1 V0.
1. OUTLINE Blockstream Jade v1 is ESP32 board which based on ESP32-D0WDQ6-V3 module. The board is made of PC+ABC. 1.1 Hardware Composition The hardware of Blockstream Jade v1: ESP32-D0WDQ6-V3, TFT screen, camera 、 Button,, TypeC-to-USB interface, Power Management chip and battery. ESP32 is a single 2.4 GHz Wi-Fi-and-Bluetooth combo chip designed with the TSMC ultra-low-power 40 nmtechnology.
2. PIN DESCRIPTION 2.1. USB INTERFACE Blockstream Jade v1 Configuration Type-C type USB interface, support USB2.0 standard communication protocol. 3. FUNCTIONAL DESCRIPTION This chapter describes the ESP32-D0WDQ6-V3 various modules and functions. 3.1.
3.3. RTC MANAGEMENT AND LOW POWER CONSUMPTION ESP32 uses advanced power management techniques may be switched between different power saving modes. (See Table 5). • Power saving mode - Active Mode: RF chip is operating. Chip may receive and transmit a sounding signal. - Modem-sleep mode: CPU can run, the clock may be configured. Wi-Fi / Bluetooth baseband and RF - Light-sleep mode: CPU suspended. RTC and memory and peripherals ULP coprocessor operation.
Press and hold the side power button for two seconds to start the device. Press and hold for more than 6 seconds to turn off the device. Switch to the photo mode through the Home screen, and the avatar that can be obtained through the camera is displayed on the tft screen.The USB cable must be connected when working, and the lithium battery is used for short-term storage to prevent power failure.
