Instructions / Assembly

PLEATED SHADE
INSTALLATION & USER GUIDE
MEASURE
INSTALLATION WITHOUT TOOLS
TM
@HOMECUT
Decide the mounting location. Use a metal tape to measure
the width and height.
• For inside mount – Measure the window width at 3
locations, including top, middle, and bottom. Use the
narrowest width minus 1/4” ~ 1/2” as your shade width.
• For outside mount – Measure the exact width of the area
to be covered. The overlap is usually 1.5”~2” on each
side.
Width
Height
MIDDLE
BOTTOM
TOP
Width
Height
WHAT IS INCLUDED:
• The pleated shade with scale – 1 unit
• The double sided tape – 1 unit
2
3
Bottom
rail
Front side
Polyester
fabric
Vinyl headrail
with the
measurement
Vinyl board for
outside mount
Back side
A sharp kitchen knife is recommended.*
• Remove the end caps from each side of the bottom rail.
Keep the Styrofoam inside the bottom rail when cutting
the shade.
• Cut out the shade width equally from each side. Place
the cutting guide at the location you want to trim
out.
• Use a sharp kitchen knife to cut the shade through rails
and fabric carefully with a rocking motion and constant
pressure.
• Repeat at another side.
Note – Recommend to cut one side only when the trimmed
width is less or equal to 1 inch.
• Put back the end caps to the bottom rail
Inside mount
Outside mount
CUT THE SHADE CAREFULLY
Styrofoam
Bottom rail
end cap
4
MOUNT THE SHADE
FOR INSIDE MOUNT
• Clean the mounting surface
• Apply the adhesive tape to the top of the headrail
tightly.
• Peel off the cover of the double sided tape.
Double sided
tape
Peel
1
Cutting guide
Cut from the
front side
Double sided
tape
Top of the
headrail