Installation Sheet

ASSEMBLY & INSTALLATION INSTRUCTIONS for TRI-05P-WH

CAUTION: READ ALL INSTRUCTIONS CAREFULLY FOR SAFE OPERATION AND INSTALLATION.

CAUTION

Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible

shock.

GENERAL

1. All electrical connections must be in accordance with local and national electrical code (N.E.C)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

qualified electrician. Remove the fixture and the mounting package from the box and make sure

that no parts are missing by referencing the illustrations on the installation instruction.

2. Dimming controller type: TRIAC phase control dimmer.

3. Recommended TRIAC dimmers: LEVITON: ILLUMATECH IPL06, SURESLIDE 6674

LUTRON: ARIADNI AYCL-153P, DIVA DVCL-153P, SKYLARK CTCL-153P, SKYLARK SCL-153P

ASSEMBLY AND INSTALLATION

1. Take the fixture out of the box.

2. Remove the back panel (10) from the decorative pan (12) by loosening four decorative thumbscrews

(11).

3. Pull the supply wires (2&8) and the house ground wire (5) out of the outlet box (1) and install cross

bar (17) to the outlet box (1) by using two mounting screws (9).

4. Place the back panel（10）over the cross bar (17) through the two outward screws (11) and

secure it by tightening two nuts (13).

5. Make the wiring connections: connect the white supply wire (2) to the white fixture wire (4);

connect the black supply wire (8) to the black fixture wire (7); connect the house ground wire (5) to the

fixture ground wire (6) using wire connectors (3).

6. Slightly loosen the horizontal wire retainer (19) by loosening the screws on either side of the barrel.

7. Temporarily mount fixture pan (12) to back panel (10) by attaching loop (16) to mating hooks (15).

Adjust the two suspension cables to appropriate length by either pushing the individual wire up into

the adjustable gripper (18) or pushing the small barrel upward (located on the bottom of the

adjustable gripper). This will release the wire tension and allow the suspended wire to increase in

length.

8. Once the wire is adjusted to approximate mounting length use the attached twist ties to retain the

excess wire into neat loops that will fit inside the fixture pan (12).

9. Secure the fixture pan (12) on the back panel (10) by tightening two decorative nuts (14).

PAGE 1
ASSEMBLY & INSTALLATION INSTRUCTIONS for TRI-05P-WH CAUTION: READ ALL INSTRUCTIONS CAREFULLY FOR SAFE OPERATION AND INSTALLATION. CAUTION Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible shock. GENERAL 1. All electrical connections must be in accordance with local and national electrical code (N.E.C) standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a qualified electrician.
PAGE 2
10. Once the canopy is in place; A- fine tune the fixture suspension cable lengths to get the fixture level and the two wires even in length. Either push the individual wire up into the adjustable gripper (18) or push the small barrel upward (located on the bottom of the adjustable gripper). This will release the wire tension and allow the suspended wire to increase in length.