Installation Instructions

8. If needed, unlock and change the pressure threshold
values (advanced users only).
9. EDI-PI will be auto-lled with the ID number from
your CAC Card. If you’re not using a CAC Card Reader,
manually enter identifying information.
10. Select the gauge state: Gauges must be On to
record events.
Use O to place them in a non-monitoring state.
Note: After activation, users can toggle state by holding
the button with a 5.56 NATO round until all three LEDs light
in sequence.
11. Click Activate Gauges. Gauges are ready for use
and can be disconnected from PC when software
displays in the side bar: Gauge Attached...Ready.
START SCAN
1. Register at blastgauge.com/software on a PC.
2. Follow email instructions to download.
Click the software version box needed to
install.
5. Connect the gauges to a PC via the Micro-USB hub.
6. Connected gauges will show up in the side bar on the
right with Gauge Not Activated below it.
If your gauges have a grey label
(Commercial) you will download from
either the Google Play Store, or the
Apple App Store.
7. Select Personnel for use on mobile people. This will
enable sleep, allowing the gauge to go inactive after 30
min. of no movement.
Select Structure for use on static objects. This disables
sleep, so gauges will never go inactive.
Note: Gauges left on in structure mode will constantly use battery.
12. On the tablet, test the Bluetooth connection by
clicking Start Scan. Gauges must be within close
proximity of the tablet and disconnected from the PC
Note: Bluetooth must be on but you do not need to connect to
any devices.
3. On a tablet, download The Blast Gauge System
Application version based on the operating system
of the device used.
If your gauges have a green label
(Interrogated Wireless
TM
) download
the software from blastgauge.com/
software using instructions provided
from the downloaded PC software
folder.
4. Open BGSM software on a PC. Go to the Activate
tab.