User's Manual

User manual

ALARM REMOTE CONTROL

Model: GD-F02D

Name:

ALARM REMOTE CONTROL

Model No.:

GD-F02D

Operation Frequency:

433.92MHz

Channel Numbers:

Modulation Type:

GFSK

Antenna Type:

PCB Antenna

Antenna Gain:

-2.0dBi

Power Supply:

DC3.0V from battery

Function introduction:

1 button (arming), 2 button (disarming); press each button once, remote

control code for 1.5 seconds.

NOTE：

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

Caution: Any changes or modifications to this device not explicitly approved by

manufacturer could void your authority to operate this equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

PAGE 1
User manual ALARM REMOTE CONTROL Model: GD-F02D Name: ALARM REMOTE CONTROL Model No.: GD-F02D Operation Frequency: 433.92MHz Channel Numbers: 1 Modulation Type: GFSK Antenna Type: PCB Antenna Antenna Gain: -2.0dBi Power Supply: DC3.0V from battery Function introduction: 1 button (arming), 2 button (disarming); control code for 1.5 seconds. press each button once, remote NOTE： This device complies with part 15 of the FCC Rules.
PAGE 2
user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help.