Installation Instructions

8.50
2
FIG. 2
1
3
7
6
5
4
FIG. 1
MUZZLE
3
Adjustable Scope Mount
WARNING
:
BE SURE YOUR GUN IS NOT
LOADED AND ON SAFE BEFORE INSTALLING THE
SCOPE MOUNT. REMEMBER TO PRACTICE SAFE
HANDLING PROCEDURES AT ALL TIMES.
INSTALLATION INSTRUCTIONS:
This is a product of BKL Technologies
For customer assistance please call toll free 1-877-255-2001
or visit WWW.BKLTECH.COM
Made in USA
!
Slide mount over dovetail of the gun or 1.
adapter plate.Secure the mount by
tightening the Clamp Screws (1).
If the mount will not fit over the dovetail, 2.
widen the mount by removing all Clamp
Screws (1) and place 3 of them into the
spreader holes (2) and tighten evenly until
mount slides over the dovetail. When
mount is positioned on dovetail, return all
screws to the clamping Holes and tighten.
Remove the Ring Caps(5) and position the 3.
scope in ring Saddles(6,7) and replace the
Ring Caps.
Loosen the Hinge Pin Base Screws (3) 4.
enough that the rings can pivot with light
friction.
With the scope secured in the rings, you 5.
can now adjust elevation. Use the Elevator
(4) to adjust pivot angle. Turn Elevator
counterclockwise to raise impact point.
Tighten Hinge Pins(3) to lock into position 6.
Adjustable Scope Mount
WARNING
:
BE SURE YOUR GUN IS NOT
LOADED AND ON SAFE BEFORE INSTALLING THE
SCOPE MOUNT. REMEMBER TO PRACTICE SAFE
HANDLING PROCEDURES AT ALL TIMES.
INSTALLATION INSTRUCTIONS:
This is a product of BKL Technologies
For customer assistance please call toll free 1-877-255-2001
or visit WWW.BKLTECH.COM
Made in USA
!
2
FIG. 2
1
7
6
5
4
FIG. 1
MUZZLE
Slide mount over dovetail of the gun or 1.
adapter plate.Secure the mount by
tightening the Clamp Screws (1).
If the mount will not fit over the dovetail, 2.
widen the mount by removing all Clamp
Screws (1) and place 3 of them into the
spreader holes (2) and tighten evenly until
mount slides over the dovetail. When
mount is positioned on dovetail, return all
screws to the clamping Holes and tighten.
Remove the Ring Caps(5) and position the 3.
scope in ring Saddles(6,7) and replace the
Ring Caps.
Loosen the Hinge Pin Base Screws (3) 4.
enough that the rings can pivot with light
friction.
With the scope secured in the rings, you 5.
can now adjust elevation. Use the Elevator
(4) to adjust pivot angle. Turn Elevator
counterclockwise to raise impact point.
Tighten Hinge Pins(3) to lock into position 6.