Operation Manual

ManualsBrandsBivar ManualsElectronicsBivar Wireless Temperature and Humidity Sensor

BIVAR OPERATION MANUAL

1. Add Gateway

1) Power supply：USB or 5V. Picture1

Noted: When you add it in APP, pleaser ensure:

i. power on the gateway

ii. 4G card has been put in

iii. Two antennas on the circuit board

2) Process

successful, you can rename the device.

2. Add sub-device

1) Click Gateway go to sub-device interface, login sub-device ID(on the back of

5V Power

4G Card

Summary of content (4 pages)

PAGE 1
BIVAR OPERATION MANUAL 1. Add Gateway 1) Power supply：USB or 5V. Picture1 5V Power 4G Card Noted: When you add it in APP, pleaser ensure: i. power on the gateway ii. 4G card has been put in iii. Two antennas on the circuit board 2) Process Login in Bivar App, click “ADD DEV”，scan QR code(on the Gateway). After add successful, you can rename the device. 2.
PAGE 2
device circuit board). 1-5 devices can be added at a time. 2) Sub-device using i. Smart Handle: Handle was supply by ER14250 (3.6V). Once it has been installed, if the handle switch is triggered, the handle will send a message through the RF 915Mhz frequency band to tell the gateway. ii. T/H sensor using: Temperature and Humidity Sensor (T&H sensor ) was supply by ER14250 (3.6V).
PAGE 3
. Sub-device device status i. ii. Click on the sub-device to enter the device status interface Normal state(temperature 18-27°)When the temperature is detected to be >0.5° or the humidity is greater than 1, the APP will push a message. When the temperature and humidity do not change, the device updates the temperature and humidity values once an hour. Abnormal state (temperature detected more than 27° or below 18°): App will push an alarm message and report the temperature and humidity value.
PAGE 4
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.